User manual ROBLIN ESPACE 900 CENTRALE DIMENSIONS

[. . . ] ⷠWhen the cooker hood is used in conjunction with other appliances supplied with energy other than electricity, the negative pressure in the room must not exceed 0. 04 mbar to prevent the fumes from combustion being drawn back into the room. ⷠThe appliance is for domestic use only and should not be operated by children or people who are infirm without supervision. ⷠThis appliance must be positioned so that the wall socket is accessible. [. . . ] Marked with the letter E or by the earth symbol - The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. - The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. ATTENTION: Do not forget to use adequate plugs to the support brackets. The manufacturer accepts no responsibility in case of a faulty hanging due to the drilling and the setting up of plugs. Extractor QUARTZ + CONFORT PRO Motor The installation of the built-in extractor QUARTZ can be carried out in 2 different ways: · Either while integrating the motor in the hood or in the kitchen furniture. ⷠEither while separating the motor, to be placed at a distance from the hood, in order to be more comfortable improving noise level Extractor QUARTZ + extern motor at a distance MISTRAL 800 The QUARTZ built-in extractor is installed in the hood or in the kitchen furniture; the MISTRAL motor is fitted at a distance from the hood on an outside wall. Position the Confort motor inlet above the Quartz and lower into position (fig 2). Fix the Confort motor assembly to the Quartz with the 2 screws (fig 3). Insert the 4 shock absorbers into the holes in the back of the Confort motor (fig 4). Cut the required aperture in the base of the kitchen cabinet as indicated (fig. Insert the extractor in the aperture in the kitchen cabinet and turning the screws clockwise secure the assembly to the kitchen cabinet (fig 6). Press against the two retaining clips, which hold the charcoal filter in place and this will allow the filter to drop down and be removed. ⷠClean the surrounding area and metal grease filters as directed above. ⷠInsert the replacement filter and ensure the two retaining clips are correctly located. Extraction tube : Check every 6 months that the dirty air is being extracted correctly. Comply with local rules and regulations with regard to the extraction of ventilated air. lighting : If the lamp fails to function check to ensure it is fitted correctly into the holder. If lamp failure has occurred then it should be replaced with identical replacement. Do not replace with any other type of lamp and do not fit a lamp with a higher rating. In the event of any malfunction or anomaly, notify your fitter who will have to check the appliance and its connection. ⷠIn the event of damage to the mains supply cable, this can only be replaced by at approved repair centre appointed by the manufacturer who will have the required tools and equipment to carry out any repairs properly. Should these warnings fail to be observed it could affect the safety of your cooker hood. [. . . ] This appliance complies with European regulations on low voltages Directive 2006/95/CE on electrical safety, and with the following European regulations: Directive 2004/108/CE on electromagnetic compatibility and Directive 93/68 on EC marking. When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European directive 2002/96/EC. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. please inform yourself about the local separate collection system for electrical and electronic product. [. . . ]