User manual ROBLIN DUNE XLS

[. . . ] Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. If the extractor is used in conjunction with non-electrical appliances (e. [. . . ] 1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the centre (notch) with the vertical reference line. 1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied), aligning the centre (notch) with the vertical line. REAR PANEL (OPTIONAL) The Rear Panel must be fitted before fixing the hood body and, for both upper an lower positiion fixing, must be fitted at the correct height prior to installing the bases. As this operation is rather complex, it should be carried out either by the kitchen installer or a qualified person who knows the final dimensions of the units. for the upper fixing position , proceed as follows: · Rest the back panel on the base, inserting the lower plate between the upper surface and the wall, centring it on the vertical reference line. Fix the back panel (where present) using the 12a (4, 2 x 44, 4) screws supplied. Before hooking up the hood body, adjust the two screws Vr located on the hood body connection points so that they are at the half way point. DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. If this is not the case, adjust the position by either reversing the connection extension pieces 14. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Slightly widen the two sides of the upper flue and hook them behind the brackets 7. Slightly widen the two sides of the flue and hook them between the upper flue and the wall, making sure that they are well seated. [. . . ] Unscrew the bulbs and replace them with new ones having the same characteristics. Remove the snap-on lamp cover by levering it from under the metal ring, supporting it with one hand. [. . . ]