User manual ROBLIN DIVA 900 S

[. . . ] Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. If the extractor is used in conjunction with non-electrical appliances (e. [. . . ] 1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied), aligning the centre (notch) with the vertical line. 1 as shown 110 mm from the vertical reference line and 180 mm above the horizontal reference line. REAR PANEL (OPTIONAL) The Rear Panel must be fitted before fixing the hood body and, if it is to be fixed at both top and bottom, must be fitted at the correct height prior to installing the bases. As this operation is rather complex, it should be carried out either by the kitchen installer or a qualified person who knows the final dimensions of the units. for fixing at the top only , proceed as follows: · Rest the back panel on the base, inserting the lower plate between the upper surface and the wall, centring it on the vertical reference line. Use the adjusting screws 12d underneath the hood to level the hood body. DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. Push fit the air outlet fitting 15 onto the air outlet of the hood body. The air outlet directional grills must be fitted after the lower outlet duct 2. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. [. . . ] When refitting the filters, make sure that the handle is visible on the outside. REPLACING THE ACTIVATED CARBON FILTERS These filters are not washable and cannot be regenerated, and must be replaced every 4 months of operation, or more frequently with heavy usage. [. . . ]