User manual ROBLIN CUBIX DIMENSIONS

[. . . ] Never use the hood for purposes other than for which it has ben designed. Never leave high naked flames under the hood when it is in operation. Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. [. . . ] mAINTENANCE · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. Ty Product Components 1 Hood Body, complete with: Controls, Light, Blower, Filters 1 Upper Chimney 1 Telescopic frame complete with extractor, consisting of: 1 Upper frame 1 Lower frame 1 Reducer Flange ø 150-120 mm 1 Damper 1 Gasket 1 Hood Body Air Outlet Extension Piece 1 Air Outlet Connection 2 Pipe clamps 1 Fixing Part of the upper Chimney 1 Air outlet connection tube Q. Dia washers M6 nuts Fixing knobs for the air outlet connection piece Use a plumb line to mark the centre of the hob on the ceiling/support shelf. Place the drilling template 21 provided on the ceiling/support shelf, making sure that the template is in the correct position by lining up the axes of the template with those of the hob. Insert two screws of the following type, crossing them and leaving 4-5 mm from the ceiling: · For concrete ceilings, use the appropriate plugs for the screw size (not provided). For wooden shelf, use 4 screws 12g with washers 22 and nuts 23, provided. Unfasten the eight metric screws joining the two columns, located at the sides of the frame. Fix the Fixing Part of the Upper Chimney 26 to the hanging kit using the 2 screws 12w (M3 x 8). Lift up the frame, fit the frame slots onto the screws up to the slot end positions. Tighten the two screws and fasten the other two screws provided; before locking the screws completely, it is possible to adjust the frame by turning it, making sure that the screws do not come out of their housing in the adjustment slot. (Reset; check the Maintenance-paragraph) indicates that the activated charcoal odour filter saturation alarm has been triggered , and the filter has to be replaced; the metal grease filters must also be washed. The activated charcoal odour filter is triggered after 200 working hours. REMOTE CONTROL (OPTIONAL) The appliance can be controlled using a remote control powered by a 1. Clean the inside as well using a damp cloth and neutral detergent; do not use wet cloths or sponges, or jets of water; do not use abrasive substances. When the above operation has been completed, hook the panel back to the hood canopy and close it by turning the knob in the opposite direction. Press button T3 for at least 3 seconds, until the leds start to flash. cleaning the filters · The filters are washable and must be cleaned when the LED S1 lights up or at least every 2 months of operation, or more frequently for particularly heavy usage. Remove the filters one at a time by pushing them towards the back of the group and pulling down at the same time. When refitting the filters, make sure that the handle is visible on the outside. The alarm signal will only light up when the extractor motor is switched on. [. . . ] Disconnect the Hood using the Main switch or the double-pole switch on the mains power supply. All five LEDs are turned on · Within 3 seconds press T1 until LEDs T1 and T4 flash in confirmation: LED flashes twice - Activated charcoal filter saturation alarm ENABLED LED flashes once - Activated charcoal filter saturation alarm DISABLED Switch off the lights and extractor motor. Press button T3 for at least 3 seconds, until the leds start to flash. Fit the new filter by hooking it into its seating · Remove the 2 screws fixing the Lighting support, and pull it out of from the Hood. [. . . ]