User manual ROBLIN CREATIX M800

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. € In the event of damage to the power cable, it must be replaced by the manufacturer or by the technical service department, in order to prevent any risks. EN 44 • If the instructions for installation for the gas hob specify a greater distance specified above, this has to be taken into account. [. . . ] € Mark a reference point (2) as indicated at 210 mm from the vertical reference line and 482 mm above the cooker top. € Repeat this operation on the other side, checking that the two marks are levelled. € Insert the bracket plugs 11a into the holes (1) and tighten the screws. 1 on the wall, about 1-2 mm from the ceiling or from the upper limit, aligning the centre (notch) with the vertical reference line. 1 on the wall at X mm below the first bracket (X = height of the upper chimney section), aligning the centre (notch) with the vertical line. € Fix the brackets using the 12a screws (4, 2 x 44, 4) supplied with the hood. 1 EN 99 Fitting the hood body • Open the doors/the door (See section Open Panels). € Adjust the two screws Vr, in the brackets 11a, so that they are at the start of their travel. € From the inside of the hood body, turn screws Vr to level the hood body itself. 11a Vr 12a Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. € To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. € Fix the pipe in position using sufficient pipe clamps (not supplied). ø 150 9 ø 120 EN 1 10 0 RECYCLING VERSION AIR OUTLET To install the hood in recycling version, the optional charcoal filter kit must be purchased. € Screw the filter cover onto the air outlet, using four screws 12c (2. € Fix the air outlet grid 8 on the recirculation air outlet using the 2 screws 12d (2, 9 x 9, 5) provided. 16 12d 8 12c Fitting the Lighting Unit • • • • • Insert the Lighting unit cable into the opening. Inside the hood canopy there is a wiring box for connection of the lighting unit. € Open the box and connect the wires to the terminal inside it, checking that the colours are combined properly. € Close the wiring box, replace the grease filters and close the doors. 12r EN 1 11 1 ELECTRICAL CONNECTION • Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. € Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan. Chimney assembly Upper exhaust Chimney • Slightly widen the two sides of the upper chimney and hook them behind the brackets 7. [. . . ] Cleaning the Filters • Remove the Filters one at a time, pushing them towards the back of the unit and at the same time pulling downward. € Wash the Filters without bending them, and leave them to dry completely before replacing. (If the surface of the filter changes colour as time goes by, this will have absolutely no effect on the efficiency of the filter itself. ) • Replace, taking care to ensure that the handle faces forwards. [. . . ]