User manual ROBLIN CREATIX BK - 5045001

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. € In the event of damage to the power cable, it must be replaced by the manufacturer or by the technical service department, in order to prevent any risks. INSTALLATION 2° USE • • • • • • • • • The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. [. . . ] € Fix the brackets using the 12a screws (4, 2 x 44, 4) supplied with the hood. 1 EN 7 7 Fitting the hood body • Open the doors/the door (See section Open Panels). € Adjust the two screws Vr, in the brackets 11a, so that they are at the start of their travel. € From the inside of the hood body, turn screws Vr to level the hood body itself. 11a Vr 12a Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. € To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. € Fix the pipe in position using sufficient pipe clamps (not supplied). ø 150 9 ø 120 EN 8 8 RECYCLING VERSION AIR OUTLET To install the hood in recycling version, the optional charcoal filter kit must be purchased. € Screw the filter cover onto the air outlet, using four screws 12c (2. € Fix the air outlet grid 8 on the recirculation air outlet using the 2 screws 12d (2, 9 x 9, 5) provided. 16 8 12d 12c Fitting the Lighting Unit • • • • • Insert the Lighting unit cable into the opening. Inside the hood canopy there is a wiring box for connection of the lighting unit. € Open the box and connect the wires to the terminal inside it, checking that the colours are combined properly. € Close the wiring box, replace the grease filters and close the doors. 12r EN 9 9 ELECTRICAL CONNECTION • Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. € Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan. Chimney assembly Upper exhaust Chimney • Slightly widen the two sides of the upper chimney and hook them behind the brackets 7. € Secure the sides to the brackets using the 4 screws 12c (2, 9 x 9, 5) supplied. Lower exhaust Chimney • Slightly widen the two sides of the chimney and hook them between the upper chimney and the wall, making sure that they are well seated. € Fix the lower part laterally to the hood body using the 2 screws 12c (2, 9 x 9, 5) supplied. At the end of this time the system will automatically return to the speed set before. Press and hold the button for approximately 5 seconds, with all the loads turned off (Motor and Lights), to turn the Activated Charcoal Filter alarm on. [. . . ] This cannot be washed or regenerated, and must be changed when the 24H led on the display starts to flash, or at least once every 4 months. The Alarm signal, if it has been activated, only appears when the Suction motor is turned on. Activating the alarm signal • In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation or at a later date. € Press button E (Intensive) until confirmation is given: • Motor Off Leds flash twice – Activated Charcoal Filter saturation alarm ACTIVATED. [. . . ]