User manual ROBLIN ASTRA

[. . . ] ⷠCheck that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. If the extractor is used in conjunction with non-electrical appliances (e. [. . . ] ⷠDraw a horizontal line at 650 mm above the hob for installation without the back panel, or at height H (height of the visible part of the panel) for installation with the back panel. 1 on the wall as shown about 1-2 mm from the ceiling or upper limit, aligning the centre (notch) with the vertical reference line. 1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied), aligning the centre (notch) with the vertical line. 1 as shown 120 mm from the vertical reference line and 175 mm above the horizontal reference line. REAR PANEL (OPTIONAL) The Rear Panel must be fitted before fixing the hood body and, if it is to be fixed at both top and bottom, must be fitted at the correct height prior to installing the bases. As this operation is rather complex, it should be carried out either by the kitchen installer or a qualified person who knows the final dimensions of the units. for fixing at the top only , proceed as follows: · Rest the back panel on the base, inserting the lower plate between the upper surface and the wall, centring it on the vertical reference line. Use the adjusting screws 12d underneath the hood to level the hood body. Push fit the air outlet fitting 15 onto the air outlet of the hood body. ⷠThe air outlet directional grills must be fitted after the lower outlet duct has been installed · Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. [. . . ] These filters are not washable and cannot be regenerated, and must be replaced approximately every four months of operation, or more frequently with heavy usage. Slide the glass cover or the metal panel to the right until the left hand end is free. [. . . ]