User manual ROBLIN ACTIS PRO 7741 ELECTRO SM DIMENSIONS

[. . . ] â· When the cooker hood is used in conjunction with other appliances supplied with energy other than electricity, the negative pressure in the room must not exceed 0. 04 mbar to prevent the fumes from combustion being drawn back into the room. â· The appliance is for domestic use only and should not be operated by children or people who are infirm without supervision. â· This appliance must be positioned so that the wall socket is accessible. [. . . ] 6) Hook the canopy item C onto the cup screws item T as illustrated fig. The canopy should be secured to the wall using the two key hole slots, whose centres are located 61 mm below cup screws. 7) Draw a horizontal line through the vertical level with the back edge of the cooking surface. Place the splashback against the wall onto the top of the cooking appliance. 8) Hook the canopy item C onto the cup screws item T as illustrated in fig. The canopy can be adjusted horizontally and vertically ensuring the canopy aligns with the splashback and the cooking appliance, by turning the adjustment screw item V. The canopy can be adjusted so that it aligns with the wall by turning the adjustment screw item V2. 9) Secure the canopy to the wall using the security fixing screw as illustrated in fig. 10) Place the noise-reduction tube item 4 over the round outlet on top of the canopy while pressing down until it snaps into position ( Fig. 5), then the non-return backflow flaps item 3 over the noise-reduction tube and duct the canopy to the outside using ducting 150 mm (6 ins) manufactured from fire retardant material , produced to BS. Before fitting the chimney to the canopy make the electrical connection as described in the section titled `'ELECTRICAL WIRING'', see as well UK specifications. 3 - Reconnect the mains supply while pushing the button 0/1 MOTOR for at least 2 seconds. 4Slacken the button 0/1 MOTOR (the Leds flash for about 3 seconds : capacity's confirmation SETUP PROCESS). 5During the flashing time select the motor type used while pushing one of the 5 buttons according to the following board: BUTTON 0/1 Light BUTTON 0/1 Motor BUTTON Speed ( - ) BUTTON Speed (+ ) BUTTON Intensive speed : : : : : Motor FABER 8/28 & 8/50 220-240 V AC / 50 Hz. REMOTE CONTROL HANDSET Caution, the remote control must be fitted with standard LR03-AAA size 1. These batteries should give a long life and constant discharge throughout their life. These batteries must be disposed of properly and could explode if damaged or exposed to heat. To obtain the best performance it is advisable to switch `ON' the cooker hood a few minutes (in the boost setting) before you start cooking and you should leave it running for approximately 15 minutes after finishing. Do not leave frying pans unattended during use as over-heated fat and oil might catch fire. Ensure heating areas on your hotplate are covered with pots and pans when using the hotplate and cooker hood simultaneously. Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean; a build up of fat or grease can be a fire hazard. [. . . ] â· In the event of damage to the mains supply cable, this can only be replaced by at approved repair centre appointed by the manufacturer who have the necessary tools and equipment to carry out any repairs properly. Should these warnings fail to be observed it could affect the safety of your cooker hood. â· When ordering spare parts quote the model number and serial number written on the rating plate, which is found on the casing behind the grease filters inside the hood. â· Proof of purchase will be required when requesting service. [. . . ]