User manual ROBLIN 900

[. . . ] If the extractor is used in conjunction with non-electrical appliances (e. Gas burning appliances), a su cient degree of aeration must be guaranteed in the room in order to prevent the back ow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. [. . . ] Caution: The position of the cutting and the squares could be modified according to the position of the frame thickness 30 mm. A plate of compensation of 50, 40 or 20 mm (provided) can be fixed at the back hood EVOLIA. To remove lighting bracket in order to reach fixings of the plate of compensation. Caution: The position of the cutting and the squares could be modified according to the position of the frame thickness 30 mm. To secure the connections with appropriate clamping rings or adhesive tape. To secure the connections with appropriate clamping rings or adhesive tape not provided. To secure the connections with appropriate clamping rings or adhesive tape not provided. To fix the charcoal foam onto the metal filters using 2 X 4 barettes. The hood can be connected to the mains supply via a double-pole switch having 3mm minimum contact gap on each pole. To insert the hood into the cutout and to fix it using the screws provided on squares. By pressing the same touch control once again or by sw itching of f the motor t his f unction c an be de activated. I ntensive s peed cannot b e a ctivated when the de lay function is on. Intensive speed has been timed at 10 minutes: H appears on the display and a spot down on the right side flashes once a second. after 10 minutes the system activates automatically the latest selected speed. [. . . ] The wires in this mains lead are coloured in accordance with the following code: Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate inside the cooker hood. This appliance is fitted with a 2 core mains cable and must be permanently connected to the electricity supply via a double-pole switch having 3mm minimum contact gap on each pole. 1363 Part 4, fitted with a 3 Amp fuse, is a recommended mains supply connection accessory to ensure compliance with the Safety Requirements applicable to fixed wiring instructions. [. . . ]