User manual RED CASTLE SHOP N JOGG DISC II

[. . . ] From birth, use the stroller with the RCS Car Seat up to 9 kgs, it conforms to the security requirements. it has been laboratory tested according to the decree 91-1992 (December 1991). Never transport more than one child in the SHOP'N JOGG DISC II stroller. Neither RED CASTLE FRANCE nor their distributors can be held responsible should this not be the case. [. . . ] Keeping hold of the axle, lower the quick release lever and turn it until it begins to tighten. - Turn the wheel to check that the disc does not rub against the disc pads. If it does, check that the axle is well fitted in the fork and/or that the red washer (8a) on the brake block is not too tight so as to allow space for the disc brake. This washer allows the brake pad located on the side of the fork to be nearer to or further from the disc. - To remove them, pull on the grey lever, removing the wheel at the same time (10). FRONT WHEEL BRAKE The SHOP'N JOGG DISC II is fitted with a front wheel brake. On the brake adjustment, refer to section 8 " Practical advice " in this instruction leaflet). PARKING BRAKE - Pushing down on the horizontal bar with your foot will lock the rear-wheels. FIXED POSITION: - Ensure the wheel is lined up straight and tighten the knob to block it in position (16). ), it is strongly recommended that the front wheel be used in the fixed position. THE SEAT BACK - The seat back has 3 positions: sitting, reclining and lying down. To change positions just open the 2 (or 4) zips on either side of the seat back. - Reclining position = 2 zips open (18) - Lying down position = 4 zips open (19) - Use the Velcro bands inside the seat, one on either side, to attach or detach the pleats in the fabric (20). hOOD and INNER NETTING HOOD The hood fits on easily: - Position the brackets as shown (21). Check that they are correctly in place, clip them on (to the hole on either side of the chassis) then secure them in place (22). - When the seat back is in the lying down position, close the press studs located at the back of the hood and/or the inner netting hood (23). For better air circulation during warmer weather, the rear of the hood unzips and detaches revealing an inner netting hood for finer weather (24). - Press on the large buttons located either side of the handlebar and keep them pressed to the required height then release them (click heard) (27). WARNING: Make sure that both suspension levers are in the same position. - To adjust the 5 point harness to fit the child's size, slide the harness adjusters A, B and C to lengthen or shorten the straps (29c). - To adjust their height: remove the shoulder pads located on the shoulder straps, open the rear of the seat back, position the straps at the required height by passing them also through the stiffener (30). WARNING: The crotch strap must ALWAYS BE USED when attaching the safety harness. [. . . ] Your stroller "pulls" to one side: - Check that all 3 tyres are at the same pressure. - Check that the front wheel is on straight, the axle is properly fitted and that the quick release levers have been tightened. - Check that both suspension levers, on the rear wheels, are in the same position. You find it hard to fold your stroller: - After cleaning the catches (45), (seen on the inside of the aluminium chassis when folding) apply some drops of silicone or liquid spray (included in the maintenance kit and available in DIY shops) as shown. [. . . ]