User manual RECARO YOUNG SPORT HERO

[. . . ] € The RECARO Young Sport Her∞ should always be fitted in accordance with the instructions, even when not in use. In the event that the driver has to brake hard in an emergency, an unattached seat may cause injury to other occupants in the vehicle. € The child seat is only approved for use for weight classes I-IIII (9 - 36kg). € For weight class I (9 - 18 kg), the child seat must only be used with the integrated restraint system. [. . . ] Use of the child seat for ECE group I (from 9 - 18kg) DE EN 1 2 2. 1 Installation of the child seat using the three-point seatbelt Öffnen Sie die Gurtklemme. 7024-4-01/1 Klick 5 Place the diagonal belt in the belt clamp (3) and close the clamp (4) with an audible click. Next tighten the belt once more in order to ensure that the child seat is held as firmly as possible. For this, simply pull the belt away from the belt clamp towards the vehicle seatbelt tensioner, and then tighten the lap and diagonal belts accordingly. Open the buckle by pressing the red button in the direction indicated by the arrow. Fasten the buckle by pushing the two tongues into one another (1) and inserting them into the buckle until it closes with an audible click (2). Tighten the straps by pulling the central belt in the direction indicated by the arrow. Pull on the yellow ratchet stop button and raise the headrest to the next position. Before adjusting the headrest, check if the insert cushion needs to be removed for the child first. In the event of the insert cushion being removed, take care when feeding the buckle and crotch pad through. Now insert the lap belt of the integral harness system from the top through the outer long slit and downwards, then thread it through the inner slits back towards the top (1). Replace the seat cushion on the seat and insert the crotch strap through the opening from above. Ensure that the T-section of the adjuster strap remains readily accessible. Place the headrest in the 2nd position from the bottom and insert the retaining belt for the shoulder pads through the slits from front to back. Insert the guide rail as shown and pass the retaining belt over the guide rail. Move the headrest up into the 3rd position and secure with the star shaped knob. Now push the shoulder pads through the slits in the headrest cover and place the cover on the headrest. Open the shoulder pads, insert the shoulder straps as shown and insert these through the headrest from front to back. Finally, close the shoulder pads and ensure, by pulling firmly on the straps, that all the connections are secure. 1 General information • The instructions for use are located in a pocket under the upholstery on the back of the seat. Once removed the cover can be washed according to the instructions on the care label. [. . . ] It is also possible that the ability to adjust the child seat headrest height may be impaired by the presence of a headrest on the vehicle seat. 2 Warranty • There is a two-year warranty from the date of purchase for manufacturing or material defects. The warranty is limited to child seats which have been used correctly and which are returned in a clean and proper condition. € The warranty does not cover natural wear and damage resulting from excessive strain or unsuitable or improper use. [. . . ]