User manual RECARO BABYZEN

[. . . ] It provides a unique mobility solution for your child, from infancy (*) to toddlerhood. We wish you the most wonderful and fascinating outdoor experience with your baby and your new BABYZENTM stroller. This interactive user guide includes all necessary instructions, illustrated on a stand-alone drawing sheet. [. . . ] Press again if necessary. Using the warning light Press the red button marked with a triangle. WARNING: the on-signal located on top of the handlebar indicates that either the driving or the warning light is on. In case of malfunction, this signal remains off. 3/10 CAUTION : always check seat and wheel frames are perfectly locked together, then pivot the stroller back on its wheels. Depending on version, the lighting system switches on automatically when unfolding the stroller, or must be switched on by pressing the ON/OFF button located under the wheeled frame central node. Installing the basket Insert the two elastic loops into the slots located at the back of the frame's central node, and fasten to the pins. Attach basket to frame by fastening together the snap buttons. Install the strap located under the basket by inserting it under the tie, so that brake cables are held against the bottom of the basket. Installing seat unit Zip up all zip fasteners on the backrest, and detach the seat touch fasteners. Insert the two backrest guide rods into the grooves located at the upper end of the frame, then slide down simultaneously to the bottom. Fully zip up the folding zip fasteners located on each side of the seat unit. 3 Seat unit components 1. Harness crotch strap. 4 Push up the guide rod for the seat front into the groove located under the seat plate. Fasten the two elastic loops for the backrest folding zips around the reels located on each side of the handlebar pivots. Engage the three elastic for fastening the seat into the hooks located under the seat plate. Fasten the elastics of the straps to the hooks on each side of the foot rest. Installing the harness Slide the harness through the touch fastener strap on the backrest. CAUTION: you MUST (i) position the harness so that it has a V shape when you are facing the pushchair, and (ii) ensure that the touch fastener on the harness is in contact with the touch fastener inside the backrest strap. Slide the harness through the opening in the backrest cushion. 5 Harness and cushions 1. CAUTION: make sure the body straps are not twisted, and that you hear a CLICK when engaging each connector. Fasten the lower part of the backrest cushion by engaging the harness adjustment straps through the two elastic loops. 4/10 To adjust shoulder strap height, unhook the touch fasteners of the harness, and move up or down. To fasten the harness buckle (i) bring together the two clips and (ii) engage into the crotch buckle, until you hear a CLICK. To unfasten the buckle, press the red button at the center. Folding the seat unit CAUTION: the seat unit MUST be folded prior to collapsing the pushchair. Pull down the two zips completely. Unhook the elastic loops that hold the zips from each side of the frame fastened. 7 The seat can recline in three different positions: - upright position - half-reclined position - reclined position To recline the seat, unzip one or two zip fasteners on each side of the backrest. CAUTION: make sure the same number of zip fasteners are unzipped on each side. Fasten the hook from below the seat to the small strap into on the backrest. 8 Fold back the front portion of the seat cushion, then cover with the backrest and its cushion. Collapsing the pushchair IMPERATIVELY rotate the handlebar in storage position, by pressing simultaneously the two command buttons at its center. Tip back the stroller on the trolley wheels, with the help of the front handle. When the seat frame is slightly reclined backwards, and the wheeled chassis is in upright position, you can complete the folding. . . . . . by pressing down GENTLY on the handle until all three wheels fold entirely flat (turn the handle counterclockwise, without overdoing). [. . . ] Before folding the stroller with its canopy, pull down the canopy over the seat. Click the canopy adapters onto the connectors on the frame, until you hear the two CLICKS for locking. [. . . ]