User manual QUANTUM CP 3100 D2D2T 05-2004

[. . . ] CERTANCE Online User's Guide CP 3100 D2D2T Solution i Copyright and Trademarks Copyright © 2004 by Certance LLC. Part Number 50001836 May, 2004 Certance and the Certance logo are trademarks of Certance LLC. Other product names are trademarks or registered trademarks of their respective owners. Certance reserves the right to change, without notice, product offerings or specifications. [. . . ] If this is the first time you are logging in, click the LOG IN button without entering a password. The Device Status page appears. NOTE: RemoteAdmin automatically logs you out after 20 minutes of idle time. If this occurs, log into RemoteAdmin, starting with step 1 on the previous page. 45 Initial Setup Setting the Initial Configuration Setting the CP 3100's Internal Clock The CP 3100 has an internal clock that tracks the current date and time. You must set the clock before you use the CP 3100. NOTE: Do not change the date or time when the CP 3100 is reading from or writing to virtual or physical tape cartridges. 1. Click CONFIGURATION. The Date/Time Settings page appears (see Figure 22 on page 46). Figure 22. Enter the information described in the Date/Time Settings page (see Table 3 on page 47). A message confirms that the date and time have been updated. NOTE: The Date/Time Settings page has a Reset button you can click to cancel your changes. If you enter the date and/or time using the wrong format, an error message appears showing the correct format to use. If this happens, click the Back button in your Browser and enter the appropriate date or time. 46 Initial Setup Table 3. Date/Time Settings Page Value Date Time Description Setting the Initial Configuration Enter the current date, in mm/dd/yyyy format. Example: 14:18:56 is equivalent to 2:18:56 PM. Specifying a Password RemoteAdmin comes configured with no password. For security purposes, enter a password to guard against unauthorized access. After entering the password, record it in Chapter 10. CAUTION: After you record the password, store it in a safe place for future reference. You will not be able to access the CP 3100 if you lose the password. 1. Click CONFIGURATION, then click CHANGE PASSWORD. The Password Settings page appears (see Figure 23 on page 47). Figure 23. 4. Setting the Initial Configuration Enter the information described in the Password Settings page (see Table 4 on page 48). Record the password in Chapter 10. NOTE: The Password Settings page has a Reset button you can click to cancel your changes. Table 4. Password Settings Page Value Old Password New Password Confirm Password Description Your current password. For security purposes, each password character appears as an asterisk (*). For security purposes, each password character appears as an asterisk (*). If this password does not match the New Password, an error message appears and the password is not changed. Configuring Network Settings The CP 3100 comes with a pre-configured IP address. When you log into RemoteAdmin for the first time, you will most likely need to change the default IP address to suit the requirements of your network. [. . . ] For example, assume that the virtual cartridge in slot 1 is named Tape 1 and has been used for a backup by the host software. Also, assume that an archive was performed to a physical tape and that the virtual cartridge in slot 1 is again used for a backup. When the archive begins, the CP 3100 97 CP 3100 Operation Archiving a Previously Archived Virtual Cartridge only archives to the same physical tape used in the first archive. Use the procedure under "Archiving to a Physical Tape for the First Time" on page 97 to erase your current physical tape using RemoteAdmin. [. . . ]