User manual PROGRESS PHP5320X

[. . . ] How to read the instruction book Safety information Step by step instructions Hints and tips Environmental information This appliance conforms to the following ECC Directives: - 2006/95 (Low Voltage Directive); - 89/336 (EMC Directive); - 93/68 (General Directive); And subsequent changes. Should the appliance be passed on to third persons or sold, or if you leave this appliance behind when you move house, it is very important that the new user has access to these user instructions and the accompanying information. installation · Installation must be carried out by qualified technicians, whilst observing the prevailing guidelines. Leave installation and connection to an expert who has the expert knowledge to carry these out in accordance with known guidelines. [. . . ] After it has been set, the minute minder will wait 3 seconds and then start running. To use or to change the minute minder setting: Press the buttons until the symbols and flash. After the time programmed has elapsed, the oven switches off automatically. Press the button " " to decrease the time until the display shows "0. Once the setting has been made, the programmer will wait 3 seconds and then start running. Oven safety switch-off The oven will switch off automatically if any change of setting is made, according to the following table (Fig. Temperature setting: 250ºC from 200 up to 245°C from 120 up to 195°C less than 120°C the oven will switch off: after 3 hours after 5. Residual heating function When a cooking time is set, the oven will automatically switch off a few minutes before the end of the programmed time, and use the residual heat to finish your dishes without energy consumption. all current settings will be displayed until the cooking time is over. This function will not operate when the cooking time is less than 15 minutes. Child lock for the oven To prevent children from switching on the oven, it is possible to lock the oven controls. To unlock the oven: Press the and " " at the same time and keep them pressed for about 3 seconds. Fast heat-up function After a cooking function and the temperature have been selected, the cavity will gradually heat up until the selected temperature is reached. This will take from 10 to 15 minutes, depending on the selected function and temperature. If it is necessary to reach the required temperature in a shorter time, the "Fast Heat Up" function can be used. When the required temperature is reached, the electronic control beeps for a short time, and the temperature display reverts to the selected temperature. Demo mode This mode is intended to be used in shops to demonstrate the oven functionality without any power consumption except the interior light, the display and the fan. This function can only be switched on when the appliance is first connected. If there is a power failure, when the power supply is restored again the Demo function can only be switched on if, in the display, are flashing 12:00 and the symbol automatically. A short acoustic alarm will be heard and the time 12:00 appears in the display (Fig. The oven is not really working and the heating elements do not switch on. Switch off the oven and follow the above described procedure to disable the demo mode. [. . . ] - The domestic electrical installation must be equipped with a proper earth connection in accordance with the regulations in force. - The socket or multi-pole off switch must be easily accessible, even after completed installation of the appliance. The appliance is shipped without a mains cable, as - depending on the type of supply available - a mains lead with a standard plug designed for the load specified on the rating plate is required. The following cable types are suitable for use as mains cables, taking into account the respective rated cross-section required: H07RN-F, H05RN-F, H05RR-F, H05VVF, H05V2V2-F (T90), H05BB-F. [. . . ]