User manual PROGRESS PEM6000E

[. . . ] · Built-in appliances may only be used after they have built in to suitable built-in units and work surfaces that meet standards. · If there is a fault with the appliance, all hotplates must be switched off and the appliance must be disconnected from the mains supply to avoid any possible electric shock. · Repairs to the appliance must only be carried out by trained, registered service engineers. [. . . ] Therefore we recommend cooking at the lowest possible temperatures and not browning foods too much. Cookware You can recognise good cookware from the bottoms of the pans. Energy saving Always place cookware on the cooking zone before it is switched on. Switch cooking zones off before the end of the cooking time, to take advantage of residual heat. Bottom of pans and cooking zones should be the same size. 4 progress Cleaning and Care Warning!Remove heavy deposits from the hotplates using fine scouring powder or a scouring pad. To maintain the hotplates, rub in a little sewing machine oil now and again and then polish off with absorbent paper. Do not clean the stainless steel edge of the hob with scouring powder or a scouring pad as this will leave scratches!For stainless steel hobs only use suitable stainless steel cleaning and maintenance products. The stainless steel edge of the plate can be slightly discoloured as a result of thermal load. This process is caused by the physical properties. What to do if . . . Problem The hotplates are not functioning Possible cause The combination appliance is not switched on The desired heat setting is not set. Set the heat setting. The fuse in the house's electrical Check the fuse. If the fuses trip wiring (fuse box) has been trip- a number of times, please call an ped. authorized electrician. If you are unable to remedy the problem by following the above suggestions, please contact your dealer or the Customer Care Department. Repairs to the appliance are only to be carried out by qualified service engineers. Considerable danger to the user may result from improper repairs. If the appliance has been wrongly operated, the visit from the customer service technician or dealer may not take place free of charge, even during the warranty period. Disposal The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ] · In the event of single-phase or twophase connection, the appropriate mains cable of type H05BB-F Tmax 90°C (or higher) must be used. · If this appliance's mains cable is damaged, it must be replaced by a special cable (type H05BB-F Tmax 90°C; or higher). The latter is available from the Customer Care Department A device must be provided in the electrical installation which allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm. [. . . ]