User manual PROGRESS 6 IN 1

[. . . ] correct use · This dishwasher is only intended for washing household utensils suitable for machine washing. Knives and other items with sharp points must be loaded in the cutlery basket with their points down or placed in a horizontal position in the upper basket. Avoid opening the door whilst the appliance is in operation, hot steam may escape. ⷠDo not take any dishes out of the dishwasher before the end of the washing cycle. [. . . ] The rows of prongs in the lower basket can lie flat to allow you to load pots, pans and bowls. Forks and spoons should be placed in the removable cutlery basket with the handles facing downwards and the knives with their handles facing upwards. Arrange items on and underneath the cup racks so that water can reach all surfaces. If the handles protrude from the bottom of the basket, obstructing the lower spray arm, load the cutlery with the handles facing upwards. For best results we recommend that you use the cutlery grid provided (if the size and dimensions of the cutlery allow it). Before closing the door, ensured that the spray arms can rotate freely. Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. Carefully lift both sides upwards until the mechanism is engaged and the basket is stable. Carefully lift both sides upwards and then allow the mechanism to drop back down slowly, keeping hold of it. Never lift or lower the basket on one side only When the basket is in the higher position you will not be able to use the cup racks. After loading your machine always close the door, as an open door can be a hazard. The consumption values are intended as a guide and depends on the pressure and the temperature of the water and al- Cleaning the filters The filters must be checked and cleaned from time to time. Turn the handle about 1/4 a turn anticlockwise and remove the filter system 4. Take hold of the coarse filter (A) by the handle with the hole and remove from the microfilter (B). Remove the flat filter from the base of the washing compartment and clean both faces thoroughly. Put the flat filter back in the base of the washing compartment and ensure that it fits perfectly under the two guides (C). Put the filter combination in place and lock by turning the handle clockwise to the stop. During this process ensure that the flat filter does not protrude above the base of the washing compartment. We recommend every 3 months you run the wash programme for heavy soiled dishes using detergent but without dishes. Prolonged periods of non-operation If you are not using the machine for a prolonged period of time you are advised to: 1. Leave the door ajar to prevent the formation of any unpleasant smells. If residues of soil have clogged the holes in the spray arms, remove the debris with a cocktail stick. [. . . ] DO NOT use connection hoses which have previously been used on an old appliance. This appliance has been fitted with safety features which will prevent the water used in the appliance from returning back into the drinking water system. Water inlet hose with safety valve After connecting the double-walled water inlet hose, the safety valve is next to the tap. Therefore the water inlet hose is only under pressure while the water is running. [. . . ]