User manual PROEL PLML250SE

[. . . ] Always disconnect from the mains, when the device is not in use or before cleaning it. This is a normal process and does not necessarily mean that the device is defective. HEALTH HAZARD: Never look directly into the light source, as sensitive persons may suffer an epileptic shock (especially meant for epileptics)!Do not switch the device on and off in short intervals as this would reduce the lamp's life. [. . . ] Turn one screw at a time to drag the hot-spot diagonally across the projected image. If you cannot detect a hot-spot, adjust the lamp until the light is even. RIGGING DANGER TO LIFE: Please consider the respective national norms during the installation. The installation must always be secured with a secondary safety attachment, e. This secondary safety attachment must be constructed in a way that no part of the installation can fall down if the main attachment fails. When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges, under high working places and other endangered areas is forbidden. The operator has to make sure that safety-relating and machine-technical installations are approved by an expert before taking into operation for the first time and after changes before taking into operation another time. The operator has to make sure that safety-relating and machine-technical installations are approved by an expert after every four year in the course of an acceptance test. The operator has to make sure that safety-relating and machine-technical installations are approved by as killed person once a year. OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to) calculating working load limits, installation material being used, and periodic safety inspection of all installation material and the If you lack these qualifications, do not attempt the installation yourself, but instead use a professional structural rigger. improper installation can result in bodily injury and/or damage to property. If the projector shall be lowered from the ceiling or high joists, professional trussing systems have to be used. If you have doubts concerning the safety of a possible installation, do NOT install the projector. DANGER OF FIRE: when installing the device, make sure there is no highlyinflammable material (decoration articles, etc. Insert the quick-lock fasteners of the first omega holder into the respective holes on the bottom of the device. ensure that the structure (truss) to which you are attaching the fixtures is secure. The Moving-Head can be placed directly on the stage-floor or rigged in any orientation on a truss without altering its operation characteristics (see the drawing). A safety rope which already hold the strain of a crash or which is defective must not be used again. DMX-CONNECTION The DMX wires must not come into contact with each other, otherwise the fixtures will not work at all, or will not work properly. Use only a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture or one fixture with another. If you are using the recommended controllers, you can connect the DMX-output of the controller directly with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX controllers with other XLR-outputs, you need to use adapter-cables. [. . . ] DEMO OPERATION The PLML250SE moving head works also without a connection to an external controller. press the MODE button and select F4 to enter into the Demo Operation mode. to disable this function , select N on the display and press ENTER to confirm. RESET The PLML250SE moving head resets all channels also without a connection to an external controller. [. . . ]