User manual PLANET BIKE INSIGHT 15 WATT

[. . . ] AB Changing Bulb/Reflector MAKE SURE BULB AND CASE ARE COOL BEFORE CHANGING BULB · Unscrew front bezel ring counterclockwise and remove bezel · Carefully pull the bulb/reflector unit out of the case · Insert the new bulb/reflector into the light case by lining up and inserting the bulb pins with the light case pin receptacles · Replace the front bezel and test the light function Technical Specifications Battery: 6 volt NiMH 4. 5 A/H Charge: 500 milli. Integrates with battery circuit to provide auto charging Bulb: MR-11 Spectra blue halogen Troubleshooting Problem: Light is turned on, but bulb does not light up. · Check cable connections for proper connection or contaminants. Part # 3017-1 Features: · New Spectra Blue Bulb - Beam Technology is 25% brighter than standard Halogens · SuperCircuitTM Power Control - w/ soft touch remote accesses 9w/12w/15w settings This product is not intended to replace your bicycle's reflectors. [. . . ] Note: The main POWER SWITCH on the top of the battery can be in either the on or off position during charging. 3) The Intellicharger feature allows you to leave the battery plugged in full time. Intellicharger then keeps your battery fully "topped-off" by "pulse" charging the battery for a few seconds each minute to maintain a full charge without risking battery damage. WARNINGS AND PRECAUTIONS: * The Intellicharger charges approximately 12 hours before reverting to "pulse" charging. Any disruption of power to the Intellicharger will reset the charging cycle. * The recharging unit is for indoor use only and is designed only for use with this lighting system. If either becomes too hot to touch, discontinue charging and contact your dealer. * Disconnect the battery cable from the light head during non use to avoid accidental light activation and possible fire hazard from heat of the bulb. Do not attempt to open the bottle cap as it can damage the unit and voids the warranty. * To ensure maximum run-time, make sure your battery is fully charged before use. * If the battery is not used for a long period of time, charge it once every three months to maintain the life of the Nickel Metal Hydride (NiMH) battery. * During long periods of non-use, unplug the charger from the battery pack. Operating the Light 1) Turn on the battery POWER SWITCH on top of the water bottle battery. After switching the power on, the headlamp will be illuminated for the first 3 seconds while the system checks the current power reserve. 2) To turn the light on, press and hold the REMOTE SWITCH for 1-2 seconds. [. . . ] Ideal tension allows for the light beam to be adjusted up or down by pushing the light case with your hand. 4) Insert POWER CORD PLUG into light case receptacle and battery pack. *Side to side beam adjustment is adjusted by loosening the screw on the bottom of the light case. [. . . ]