User manual PHILIPS SCD463

[. . . ] ) Put the small plug in the parent unit and put the adapter in a wall socket. Even if you do not intend to use the baby monitor on batteries, we advise you to insert batteries into both units. Replace the batteries when the power-on light blinks red when you operate the baby monitor on batteries. Make sure your hands and the units are dry when you insert the batteries. [. . . ] , Parent unit: turn the locking knob in the bottom a quarter turn (1) and slide the battery compartment lid downwards to remove it (). Use a small, flat screwdriver to turn the channel selector to the desired position. 1) , If you do not experience any interference when you test the connection, close the battery compartments. If you experience interference, set the selector to another channel and test the connection again. If you run the units on battery power, put the batteries back in the battery compartments. Microphone sensitivity control With the microphone sensitivity control on the baby unit, you can set the sound that is picked up by the baby unit to the desired level: low, mid or high. When the microphone sensitivity is set to `high', the baby unit picks up all sounds. You can only change the microphone sensitivity if the connection Between the baby unit and the parent unit has been established. This is the case when the connection light on the parent unit burns green continuously , Use the microphone sensitivity control to set the microphone sensitivity of the baby unit to the desired level. 15) The power-on light on the baby unit turns yellow when a sound is picked up. connection alarm You can switch on the connection alarm on the parent unit. The connection alarm beeps when the connection between the units is lost. 1 Turn the locking knob in the bottom a quarter turn (1) and slide the battery compartment lid downwards to remove it (). 16) Slide the battery compartment lid back onto the battery compartment (1) and turn the locking knob in the bottom a quarter turn to fasten the lid (). Do not immerse the parent unit and the baby unit in water and do not clean them under the tap. Storage 1 Remove the batteries if the units are not going to be used for a month or more. Guarantee and service If you need information or if you have a problem, please visit the Philips website at www. Com or contact the Philips Customer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic appliances and Personal Care BV. Environment , , Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. Do not throw empty batteries away with the normal household waste, but hand them in at an official collection point. Always remove the batteries before discarding the appliance or handing it in at an official collection point. [. . . ] Put the parent unit closer to the baby unit in a place where it has better reception. Please note that it takes about 30 seconds before the connection is re-established when you move one or both of the units. Why does the parent unit react too slowly to the baby's sounds?Answer You may get interference when the parent unit is out of range of the baby unit. [. . . ]