User manual PHILIPS SBCRU254-00H

[. . . ] After installing the remote control you can operate a maximum of 4 different appliances with it: TV, DVD, video recorder and satellite or cable decoders. You can find information about how to prepare this remote control for use in the chapter `Installing the remote control'. 2. Installing the remote control Inserting the batteries 1 Press the cover inwards and slide it in the 2 3 direction of the arrow. [. . . ] The example below (TV) instructs you how to do this. You can repeat the same steps for other appliances (DVD, video recorder, etc. ) which you want to operate using the RU254. Example of TV: 1 Turn on the TV manually or use the original remote control. 2 Look up the brand of your TV in the code list at the back of this manual. (See `Testing the remote control'. ) English 5 Setting the remote control 4 Keep keys `1' and `3' pressed simultaneously for three seconds until the green indicator light remains lit. 5 ­ 6 ­ Then enter the code noted in step 2 using the digital keys. If the light flashes once for an extended period, the code has not been entered properly or the wrong code has been entered. If the TV responds to all of the key commands, the RU254 is ready for use. If the device does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list. · RU254. qxd 04-06-2004 16:56 Pagina 6 Instructions for use Automatically setting the remote control If you cannot find the right code for your brand device, the remote control can automatically search for the right code. Example of TV: 1 Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1). The RU254 emits the `switch off TV' signal for all models of TV that are stored in the memory. · If the device is a DVD-player or video recorder, insert a disk or tape and start playback. 2 Then keep keys 1 and 3 on the RU254 pressed simultaneously for three seconds, until the green indicator light remains lit. English 6 3 Press the Standby key of the RU254 briefly. ­ The RU254 now starts emitting all known `TV off ' signals, one by one. Each time a code is sent, the green indicator light flashes. 4 ­ When your TV switches off (stand-by), you press the Standby key of the RU254 twice within 1 second, to confirm. The RU254 has now found a code that works on your TV. 5 · Check if you can operate all functions on your TV with the RU254. [. . . ] The VOL ­ /VOL + and s (Mute) keys give direct access to the TV volume even if you are operating your VCR, DVD or SAT equipment. If the device does not respond at all, or not to all of the key commands, follow the instructions under `Setting the remote control'. It is possible that you must enter another code for the device. RU254. qxd 04-06-2004 16:56 Pagina 56 Codes SETUP CODES FOR TV TV C O D E L I ST A. R. [. . . ]