User manual PHILIPS MC-30

[. . . ] MC-30 Micro HiFi System 1 3140 115 27913 pg 001-021/MC30/22-Eng 1 12/7/00, 1:32 PM Important notes for users in the U. K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: Italia DICHIARAZIONE DI CONFORMITA' Si dichiara che l'apparecchio MC-30 Philips risponde alle prescrizioni dell'art. Fatto a Eindhoven Philips Consumer Electronics Philips, Glaslaan 2 5616 JB Eindhoven, The Netherlands 1 2 3 Remove fuse cover and fuse. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. [. . . ] PROGRAM disappears, the preset number and the frequency of the preset station are shown. Repeat the above four steps to store other stations. TIMER ON·OFF PROGRAM REW à /í REV MODE/ BAND RECORD VOLUME Tuning to radio stations 1 2 3 Select TUNER source. The radio automatically tunes to a station with sufficient reception. Repeat step 3 if necessary until you find the desired station. ¶ You can override a preset station by storing another frequency in its place. 4 Tuning to preset stations ¶ Press PRESET 4 or 3 ( ¡ or TM on the remote control) until the desired preset station is displayed. ¶ To tune to a weak station, press TUNING 3 or 4 briefly and repeatedly until you have found optimal reception. RDS (some versions only) Programming radio stations You can store up to a total of 40 radio stations in the memory. Automatic programming Automatic programming will start with a chosen preset number. From this preset number upwards, former programmed radio stations will be overridden. The system will only programme stations which are not in the memory already. Radio Data System is a service that allows FM stations to show additional information. If you are receiving a RDS station, and the station name are displayed. When automatic programming is used, RDS stations will be programmed first. Scrolling through different RDS information ¶ Press RDS briefly and repeatedly to scroll through the following information (if available): ­ Station name ­ Programme type such as NEWS, SPORT, POP M . . . ­ Radio text messages ­ Frequency 1 Press PRESET 4 or 3 ( ¡ or TM on the remote control) to select the preset number where programming should start. Note: ­ If no preset number is selected, default is preset (1) and all your presets will be overridden. 14 3140 115 27913 pg 001-021/MC30/22-Eng 14 12/7/00, 1:33 PM Tuner Note: ­ If you press RDS and the RDS signal is not available NO RDS is displayed. RDS News and Traffic Announcement (TA) You may set up the tuner in such a way that listening to CD or tape is interrupted by the NEWS of a RDS station. This only works if the RDS station broadcasts a NEWS signal while sending the news. EON Enhanced Other Network allows you to search for an RDS station offering a certain programme type. If EON is available, is shown. 1 2 Tune to the desired RDS station. Notes: ­ To avoid unwanted recordings, the NEWS announcement does not work while recording a cassette. ­ When you receive RDS news or traffic announcements during CD playback, playback will pause and you will be able to hear the news/TA. In tape mode, the tape continues playing but you will hear the news/TA only until the broadcast has finished. ­ If you are using the RDS NEWS announcement with an EON station, the whole network is searched for the respective news. Searching programme type (PTY) PTY helps you find a desired programme type. To enable PTY, first programme RDS stations into the tuner memory (see Programming radio stations) 1 2 3 While receiving an RDS station, press RDS briefly until the programme type is displayed. Press PRESET 4 or 3 ( ¡ or TM on the remote control) until the desired programme type is displayed. Press and hold down on TUNING 3 or 4 ( à or á on the remote control) to start searching. [. . . ] 2 x 10 W RMS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 ­ 20000 Hz, ± 3 dB Input sensitivity AUX . . . . . . . . . . . . . . . . . . . . . . . 32 -1000 CD PLAYER Frequency range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 ­ 20000 Hz Signal-to-noise ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]