User manual PHILIPS HR7754

[. . . ] do not exceed the maximum content indicated on the bowl or the blender jar. Consult the table in this user manual for the correct processing times. Thoroughly clean the parts that come into contact with food before you use the appliance for the first time. If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today. [. . . ] - If you chop onions, use the pulse function a few times to prevent the onions from becoming too finely chopped. - The standard processing time for all chopping jobs is 30-60 seconds. If food sticks to the blade or to the inside of the bowl: 1 Switch off the appliance. 3 Remove the ingredients from the blade or from the wall of the bowl with a spatula. Built-in safety lock: the kneading accessory only works when the blender cap is assembled properly on the motor unit and the lid is assembled properly on the bowl. Always put the kneading accessory in the bowl before you add the ingredients. Do not exert too much pressure on the pusher when you press ingredients down the feeding tube. Built-in safety lock: the inserts only work when the blender cap is assembled properly on the motor unit and the lid is assembled properly on the bowl. When you shred or granulate soft ingredients, use a low speed to prevent the ingredients from turning into a puree. When you have to process a large amount of ingredients, process small batches and empty the bowl between batches. När du river eller finfördelar mjuka ingredienser ska du använda en låg hastighet för att förhindra att ingredienserna blir till puré. Milk), do not put more than 1 litre in the blender jar to avoid spillage. - If you are not satisfied with the result, switch off the appliance and stir the ingredients with a spatula. Remove some of the contents to process a smaller quantity or add some liquid. If ingredients stick to the wall of the blender jar: 1 Switch off the appliance and unplug it. 2 Open the lid and use a spatula to remove the ingredients from the wall of the jar. Note: It is not possible to use the food processor bowl when the blender is attached to the motor unit. Always unplug the appliance before you remove accessories or clean the motor unit. To clean the Click & Go button, unscrew it by turning it anticlockwise. Clean the lid in the dishwasher or let it soak in warm water with some washing-up liquid for a while and then rinse it under the tap with fresh water. If the Click & Go button is still dirty after cleaning in the dishwasher, clean it in the dishwasher a second time. You can quickly and easily preclean the food processor bowl and blender jar with the CLEAN button. [. . . ] The thermal safety cut-out has probably cut off the power supply to the appliance because the appliance has overheated. 1) Unplug the appliance 2) Let the appliance cool down for 60 minutes 3) Put the mains plug in the socket 4) Switch on the appliance again. Take the lid off the bowl, unscrew the Click & Go button by turning it anticlockwise and clean the lid in the dishwasher. If there is still dirt in the Click & Go button, clean the lid in the dishwasher a second time. [. . . ]