User manual PHILIPS HQ 7363

[. . . ] This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver. General - The adapter transforms 100-240 volts to a safe low voltage of less than 24 volts. electromagnetic fields (EMF) This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today. [. . . ] 4 Put the protection cap on the shaver every time you have used it, to prevent damage to the shaving heads. Trimming You can use the trimmer to groom your sideburns and moustache. Always check if the water is not too hot, to avoid burning your hands. Note:Water may leak from the socket at the bottom of the appliance when you rinse it. Every day: shaving unit and hair chamber 1 Switch off the shaver, remove the adapter from the wall socket and pull the appliance plug out of the shaver. 3 Rinse the hair chamber and the inside of the shaving unit under a hot tap for some time. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. 6 Open the shaving unit again and leave it open to let the appliance dry completely. You can also clean the hair chamber without water by using the brush supplied. Every six months: shaving heads 1 Press the release button to open the shaving unit, turn the lock anticlockwise (1) and remove the retaining frame (2). Note: Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. Put the retaining frame back into the shaving unit and turn the lock clockwise. 1 Switch off the shaver, remove the adapter from the wall socket and pull the appliance plug out of the shaver. 3 Lubricate the trimmer teeth with a drop of sewing machine oil every six months. Replacement Replace the shaving heads every two years for optimal shaving results. Replace damaged or worn shaving heads with HQ8 Philips shaving heads only. note: Do not mix up the cutters and the guards to guarantee optimal shaving performance. 1 Switch off the shaver, remove the adapter from the wall socket and pull the appliance plug out of the shaver. Put the retaining frame back into the shaving unit and turn the lock clockwise. [. . . ] 2 Let the shaver run until it stops, undo the two screws in the hair chamber and remove it. 3 Undo the two screws at the back of the shaver and remove the back panel of the housing. Do not connect the shaver to the mains again after you have removed the battery. Guarantee & service If you need service or information or if you have a problem, please visit the Philips website at www. [. . . ]