User manual PHILIPS HQ6720

[. . . ] for the best shaving results , shaving emulsion should be pumped up frequently. If the mains cord of this appliance is damaged, it must always be replaced by Philips or a service centre authorised by Philips in order to avoid hazardous situations. Shaver, the pilot light goes The red pilot light blinks when the batteries are almost empty. When the batteries are almost empty, the red pilot light blinks a few times after the shaver has been switched off. [. . . ] When you have run out of shaving emulsion, you can also use the shaver without it on a dry face. Your skin may need 2-3 weeks to get accustomed to the Philishave system. Put the protection cap on the shaver every time you have used it, to prevent damage. Remove the cartridge and clean the shaver if you are not going to use the appliance for more than one week. Rinse the shaving unit and the hair chamber with hot water (60cC - 80cC) after every use. Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time. Never dry the shaving unit with a towel or tissue as this may damage the shaving heads. Make sure the inside of the shaving unit and the hair chamber have been cleaned properly. Replace the shaving heads every two years for optimal shaving results. Put the retaining frame back onto the shaving unit, press the wheel and turn it clockwise. Replace damaged or worn shaving heads with Philishave HQ167 Cool Skin shaving heads only. Do not throw the batteries away with the normal household waste, but hand them in at an official collection point. You can also take the appliance to a Philips service centre, which will remove them for you and will dispose of them in an environmentally safe way. Let the shaver run until it stops, undo the screws and open the shaver. Do not put the shaver back into the charging stand after the batteries have been removed. The shaver comes with two different kinds of shaving emulsion: an emulsion for sensitive skin and a fresh gel. This gives you the opportunity to try them out and discover which one suits your skin type best. The shaving heads do not move smoothly over the skin: Press the pump button a few times until a sufficient amount of NIVEA FOR MEN shaving emulsion has been released to allow the shaving heads to move smoothly over your face again. The shaver has not been cleaned immediately after use and/or has not been rinsed long enough and/or the water used to rinse the shaver was not hot enough. Clean the shaver thoroughly before you continue shaving (see 'Cleaning'). [. . . ] If the irritation does not disappear within 24 hours, we advise you to stop using the shaving emulsion and to contact your doctor. The following accessories are available: - HQ167 Philishave Cool Skin shaving heads. - HQ110 Philishave shaving head cleaner (shaving head cleaning spray). If you need information or if you have a problem, please visit the Philips Web site at www. [. . . ]