User manual PHILIPS GC4596/40 STEAMGLIDEPLUS

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual PHILIPS GC4596/40 STEAMGLIDEPLUS. We hope that this PHILIPS GC4596/40 STEAMGLIDEPLUS user guide will be useful to you.


PHILIPS GC4596/40 STEAMGLIDEPLUS : Download the complete user guide (3060 Ko)

Manual abstract: user guide PHILIPS GC4596/40 STEAMGLIDEPLUS

Detailed instructions for use are in the User's Guide.

[. . . ] , Aqua+), starch, descaling agents, ironing aids, chemically descaled water or other chemicals as they may cause water spitting, brown staining, or damage to your appliance. ENGLISH 1 Set the steam control to position 3 Close the water filling door. Acrylic, nylon, polyamide, polyester) Temperature setting MAX ●●● ●● ●● ● No steam Auto steam control Automatically adjusted to the optimal amount Steam boost Yes Yes No No No Note: As indicated in the table above, do not use steam or steam boost at a low temperature, otherwise hot water may leak from the iron. [. . . ] According to the temperature you select, the iron automatically provides the optimal amount of steam for the best result. 6) 8 ENGLISH Note: Make sure that the base sits on a stable and level surface. It is recommended to place the base on the soft part of the ironing board. 4 The light ring starts to flash blue light, indicating the iron is heating up. The light will indicate the status of the iron, and remind you to charge the iron after 20 to 25 seconds to ensure a good wrinkle removal performance. Note: to ensure good wrinkle removal performance, always put the iron on its base during the resting period. 9) Table 2 Light status Iron status Instructions Flashing blue Steady blue Flashing orange Slow breathing blue (specific types only) Features Heating up Ready for use The iron needs to be charged now Safety auto-off has been activated Wait for iron to be ready. refer to Chapter “Features” , section “safety auto-off ”. Spray function -- Press the spray button to moisten the garment to be ironed.  6) 5 Remove the iron when the light ring turns steady blue. Keep pushing the calc clean button and gently shake the iron forth and back until all water in the water tank has been used up. Caution: While scale is flushed out, steam and boiling water also come out of the soleplate. €2) ENGLISH 11 Note: Repeat the Calc-Clean process if the water that comes out of the iron still contains scale particles. 3 Move the iron gently over a piece of cloth to remove any water stains on the soleplate.  16) Remove iron from the base when you wind the cord, as the soleplate could still be hot. 18) Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. €If you are unable to solve the problem with the information below, visit www. Com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country (see the worldwide guarantee leaflet for contact details). [. . . ] Com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country (see the worldwide guarantee leaflet for contact details). Put the iron back to the base until the light ring turns steady blue light, indicating that the iron is ready for use again. 12 ENGLISH Possible cause Solution Problem The steam control is set to . [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE PHILIPS GC4596/40 STEAMGLIDEPLUS




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual PHILIPS GC4596/40 STEAMGLIDEPLUS will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.