User manual PHILIPS FW880P

[. . . ] Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. How to connect a plug The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: · Connect the blue wire to the terminal marked N or coloured black. · Connect the brown wire to the terminal marked L or coloured red. [. . . ] You can load up to three discs in the CD changer for continuous playback without interruption. 15 English Loading the CD Changer v v v FW880P-880W/22-Eng 6/15/00 4:07 PM Page 16 CD 3 CD Direct Play You can play a CD directly by pressing the 3 CD DIRECT PLAY (1 - 3) buttons. ­ When the button is green, it indicates that there is no disc loaded in the disc tray. ­ When the button is red, it indicates that there is a disc loaded in the disc tray. Disc Change You can change the outer 2 discs while the third inner disc is at the stop or playing mode. · If you press DISC CHANGE again during playback, the CD will stop playing. TM The CD carousel will rotate until the inner tray is at the left hand side and is ready for changing. 3 Press OPEN·CLOSE to close the CD compartment. Searching for a particular passage during playback · Press and hold à or á until the desired passage is located. · Play returns to normal when à or á is released. English 16 Programming Tracks Programming tracks of a loaded CD is possible in the stop mode. When 40 tracks are stored and you attempt to store another track, the display will show "PROGRAM FULL". · You can also key in the track number directly from the remote control. TM The total number of tracks programmed and total playing time appear on the display. Playing a CD 1 Press PLAY É to start playback. TM The disc tray, track number and elapsed playing time of the current track appear on the display. The program flag will also temporary disappear from the display and then reappear, when the playback for the selected disc ends. FW880P-880W/22-Eng 6/15/00 4:07 PM Page 18 TUNER DOLBY PRO LOGIC 20+ 18 17 16 15 14 13 CD TEXT 12 11 10 9 DBB TM The system will remain tuned to the last stored preset radio station. · Repeat the above procedure to store other preset stations for the other waveband. Remember to select the next available preset number before proceeding. If not, some of the preset radio stations may be erased. TUNING CLEAR SIDE A · B Tuning to radio stations 1 Press TUNER to select TUNER mode. A few seconds later, the current frequency or the radio station name if available will be displayed. 2 Press TUNER (BAND) again to select the desired waveband : FM, MW or LW. 3 Press TUNING à or á for more than one second, then release. TM The display will show `SEARCH' until a station with sufficient signal strength is found. · To tune to a weak station, briefly press TUNING à or á until the display shows the desired frequency and/or when the best reception has been obtained. Storing Preset Stations You can store up to 40 stations in the memory. When a preset radio station is selected, the preset number appears next to the frequency on the display. 2 Press TUNER (BAND) again to select the desired waveband : FM, MW or LW. [. . . ] 3 You can program the tracks in the order you want them to be recorded (see Programming Tracks). 6 Press SIDE on the remote control to change the desired direction of the play mode. TM The FRONT or BACK flag will be displayed, depending on the side selected. å 7 Press REV MODE to select the play mode (å or ) for tape deck 2. [. . . ]