User manual PHILIPS FW326

[. . . ] Q The lens may cloud over when the system is suddenly moved from cold to warm surroundings, making it impossible to play a disc. Leave the system in the warm environment until the moisture evaporates. Q The mechanical parts of the set contain selflubricating bearings and must not be oiled or lubricated. q When the system is switched to Standby mode , it is still consuming some power. [. . . ] ­ Do not use old and new or different types of batteries in combination. ­ Batteries contain chemical substances, so they should be disposed off properly. Notes for remote control: ­ First select the source you wish to control by pressing one of the source select keys on the remote control (for example CD, TUNER). If you do not complete the Plug and Play installation, the function will be restarted when you next turn on the main supply again. Notes: ­ When the power is turned on, the disc tray may open and close to initialise the system. If no stereo frequency is detected during Plug and Play , "CHECK ANTENNA" will be displayed. ­ During Plug and Play, if no button is pressed within 15 seconds, the system will exit Plug and Play mode. All available radio stations with sufficient signal strength will be stored automatically, starting from FM and followed by MW and LW band. When all the available radio stations are stored or the memory for 40 presets are used, the last preset radio station will be played. Note: ­ If you have not deactivated the demonstration, it will resume five seconds after the system switches to standby mode. To listen through the headphones q Connect the headphones plug to the n socket at the front of the system. Notes: ­ If the total playing time is more than "99:59" or if one of the programmed tracks has a number greater than 30, then "--:--" is displayed instead of the total playing time. ­ If you attempt to programme more than 40 tracks, "FULL" is displayed. ­ If you press any of the CD DIRECT 1/2/3 buttons on the remote control, the system will play the selected disc or track, and the stored programme will be ignored temporarily. ­ During programming, if no button is pressed within 20 seconds, the system will exit the programme mode automatically. Press and hold à or á until the frequency indication starts to change, then release. The display will show "SEARCH" until a radio station with sufficient signal strength is found. Q To tune to a weak station, press à or á briefly and repeatedly until optimal reception found. To begin automatic preset from a desired preset number q Press í or ë to select the desired preset number. If a radio station has been stored in one of the presets, it will not be stored again under another preset number. All available radio stations with sufficient signal strength will be stored automatically, starting from FM and followed by MW and LW band. When all the available radio stations are stored or the memory for 40 presets are used, the last preset radio station will be played. [. . . ] ­ The volume of the timer will increase gradually from the minimum level to the last tuned volume level. To start from a specific track, make a programme (refer to "CD Operation - Programming the disc tracks"). Before the system switches to standby mode, a countdown of 10 seconds is displayed. Notes: ­ When the preset time is reached and the selected disc tray is empty, the next available disc will be selected. [. . . ]