User manual PHILIPS FW-C155

[. . . ] Q Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. Q Place the system in a location with adequate ventilation to prevent internal heat build-up in your system. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from each side. Q Do not expose the system, batteries or discs to excessive moisture, rain, sand or heat sources caused by heating equipment or direct sunlight. [. . . ] ­ During Plug and Play, if no button is pressed within 15 seconds, the system will exit Plug and Play mode. Note: ­ If you have not deactivated the demonstration, it will resume five seconds after the system switches to Eco Power standby or standby mode. DIM mode Brightness normal half half normal Spectrum Analyser off on off on To listen through the headphones q Connect the headphones plug to the n socket at the front of the system. You can manually select the DBB setting that best suits your listening environment. DSC (Digital Sound Control) The DSC feature enables you to enjoy special sound effects that have preset equaliser settings, providing the best music reproduction. Note: ­ Some discs or tapes might be recorded in high modulation, which causes a distortion at high volume. Therefore, do not use any accessories such as disc stabiliser rings or disc treatment sheets, etc. , as offered on the market, because they may jam the changer mechanism. This system can playback all digital audio CD, finalised digital audio CD-Recordable (CDR) discs and finalised digital audio CD-Rewritable (CDRW)discs. The selected disc tray, total number of tracks and the playing time will appear on the display. ­ To ensure good system performance, wait until the disc tray completely reads the disc(s) before proceeding. A disc is loaded in the disc tray the current selected disc tray is empty the current selected disc tray is loaded or playing The disc tray will close to retrieve the inner disc, then reopen with the inner disc accessible. During playback, the selected disc tray, track number and elapsed playing time of the current track are displayed. To play the selected disc only q In CD mode, press CD 1, CD 2 or CD 3 on the system. You can select and change the various play modes before or during playback. To search for a particular passage during playback q Press and hold à or á and release it when the desired passage is located. To select a desired track q Press í or ë repeatedly until the desired track is displayed. Note: ­ In Shuffle mode, pressing í will cause the player to skip only to the beginning of the current track. To skip to the beginning of the current track during playback q Press í once. Notes: ­ During programme play or shuffling mode, it is not possible to repeat playback the current disc (Repeat Disc mode). Q Press Ç once when playback is stopped or twice during playback. Note: ­ The programme will be erased when the system is disconnected from the power supply or when the disc tray is opened. [. . . ] Q You can programme the tracks in the order you want them to be recorded (refer to "CD Operation - Programming the disc tracks"). When in Eco Power standby mode, it is not possible to show the clock time or set the clock/timer function. To view the clock in any source mode (CD or TUNER for example) q Press CLOCK· Notes: ­ The clock setting will be cancelled when the power cord is disconnected or if a power failure occurs. ­ During clock setting, if no button is pressed within 90 seconds, the system will exit clock setting mode automatically. [. . . ]