User manual PHILIPS FR760

[. . . ] To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. if the mains plug contains a fuse , this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. [. . . ] As a minimum we recommend 5 speakers (2 front, a center, 2 surround) for good surround sound. It is possible to reproduce some kind of surround sound with fewer speakers. This is done by redirecting the signals which are foreseen for the missing speakers to the existing ones. See "Menus" on how to set up the receiver correctly for the number and size of the speakers used. Positioning the front speakers The front speakers should be placed right and left in front of the listening position like usual stereo speakers. Positioning the center speaker The center speaker should be placed in the center between the two front speakers, e. The best height for the center speaker is the height of the listener's ears (while seated). Positioning the surround speakers The surround speakers should face each other and be in line with, or slightly behind the listener. Positioning the subwoofer A subwoofer can be used to enhance the bass performance of your system dramatically. The subwoofer can be positioned anywhere in the room, because it is not possible to locate the source of deep tones. Nevertheless, you should not place the subwoofer in the middle of a room, since the bass could be severely weakened. If the receiver is used at very high power, it can produce distortions which may seriously damage your speakers. If distortions occur, reduce the volume and the tone controls to a level where the sound is acceptable again. If this happens, switch the set off and let it cool down before reusing it. The receiver switches to STEREO and surround sound will be reduced to a stereo signal which is reproducible by standard headphones. If you wish to enjoy surround sound again, switch the receiver back to surround sound. Signs showing you various settings and information about the status of the receiver. The display of the receiver is divided into 3 sections, which are to be used for the following: Menu indication These signs show you if the menu is on or off and indicate in which direction you may move. You may move up in an option list using X MENU NAVIGATOR ("up" key on the remote control). You may move down in an option list using X MENU NAVIGATOR ("down" key on the remote control). You may move forward to the next menu topic using NEXT 2 ("right" key on the remote control). This area is used for feedback of the receiver, tuner frequencies, menu options, values and scrolling text messages. [. . . ] After programming radio stations, you might want to change their sequence. YThe selected preset number <-> and a second preset number are displayed. YRESHUFFLED is displayed briefly and these two preset numbers are swapped. If you are receiving an RDS station, R and the station name are displayed. [. . . ]