User manual PHILIPS FR752

[. . . ] Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: · Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow). Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. [. . . ] 2 Connect: ­ Left front speaker to L (red and black) ­ Right front speaker to R (red and black) ­ Center speaker to CENTER (blue and black) ­ Left surround speaker to SURROUND L (grey and black) ­ Right surround speaker to SURROUND R (grey and black) You may use your Philips TV with CINEMA LINK as the center speaker. for TVs with a scart connector an additional audio cinch-to-scart cable is needed. For TV's with cinch connectors additional cinch cables are needed. Look into the instruction manual of your TV on how to use it as the center speaker. You should be at your usual listening position when adjusting the speaker volume. See "Receiver menus" on how to set up the receiver for the used speakers. Ideally, the volume in the listening position should be the same from all speakers. Note: If you are not completely satisfied with the volume settings, we recommend making minor adjustments to them during surround sound playback. General hints for positioning Avoid positioning the speakers in a corner or on the floor as this will boost the bass tones too much. Each room has different acoustic characteristics and the positioning possibilities are often limited. You can find the best position for your speakers by referring to the picture above. The different menu options are related to each other in a logical way. Let's assume you have no center speaker connected, and therefore switched CENTER LS to NO. If you try to use VOL CENTER, a message will be scrolled that this is not possible (INSTALL CENTER SPEAKER). You can leave any option (values remain unchanged) by pressing 1 PREV. Chooses the speaker sizes of the used speakers, for optimal sound reproduction. The distance between the usual listening position and the speakers defines the delay time for the surround sound. Note: When using the 6 CHANNEL / DVD IN input, these values cannot be changed. If the receiver is connected to a Philips CINEMA LINK TV via the CINEMA LINK system control bus sockets (see "CONNECTIONS"), you may use the TV to set up the system. Press CINEMA LINK to switch the connection between the receiver and the TV either on or off. If CINEMA LINK is switched on and the TV menu is active, TV MENU is displayed and the menu and sound functions on the receiver are locked. When selecting a source by turning SOURCE SELECTOR, the audio inputs ­ and video inputs (FR 760 only) ­ with the corresponding name are activated. [. . . ] Most ordinary stereo tapes and discs can be replayed using surround sound settings with good results. if the reproduction is distorted in surround mode , switch to normal stereo mode. The availabilty of the various surround sound modes described depends on the number of speakers used and the incoming sound information. SURROUND <PRO LOGIC> The surround mode enables normal surround sound reproduction with 4 or 5 speakers. [. . . ]