User manual PHILIPS CDR770

[. . . ] Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury. For Customer Use: Read carefully the information located at the back plate of your CD recorder/player and enter below the Serial N°. The CD (compact disc) revealed to you the new dimensions of digital sounds and added to the pleasures of audio. Compact disc technology permits a high contrast in loud as well as in quiet passages, with perfect channel separation. [. . . ] The Serial Copy Management System (SCMS) only allows digital recording under specific conditions: - This means that it is not possible to make a digital copy from a digital copy. Recordings from DAT or DCC players will not always stop automatically. - RECORD DISC - to make a synchronized recording of the complete disc or a program simply by starting the source. - RECORD TRACK - to make a synchronized recording of a single track simply by starting the source. - REC(ord) MANUAL - to manually start a recording simply by pressing the RECORD key. - MAKE CD - to make a synchronized recording of the complete disc or a program simply by starting the source. Some remarks on recording: - When Auto track is ON (default setting), track numbers will automatically be increased during recording. If you want to play the recorded CDR disc on any regular CD player, it must first be finalized. § The CD recorder automatically starts to record and d lights continuously. ⷠIf, however, you start the source during a track, recording starts at the beginning of the next track or after 2. (This can also be done during recording) · The EASY JOG/ENTER key can be used to adjust the recording level. If STOP 9 was pressed within 3 seconds after pressing PLAY, no recording will take place. Important: - Recording from CD-changers should always be started in the RECORD DISC, RECORD TRACK or MAKE CD mode. Preparing for autostart recording 1 Make sure the disc is absolutely free of scratches and dust particles. 2 Press SOURCE repeatedly until (depending on the connection used): § DIGITAL I, OPTICAL I or ANALOG lights up and DIGITAL 1, OPTICAL or ANALOG appears on the display. Note: - Recordings from DAT, DCC or analog sources will only stop after 20 seconds silence. If you want to play the recorded CDR disc on any regular CD player, it must first be finalized. 3 With the recorder stopped, press REC TYPE three times to enter the Manual Record standby mode. § MANUAL starts to flash and the display shows REC MANUAL. Important: - Recording from CD-changers should always be started in the RECORD DISC, RECORD TRACK or MAKE CD mode. Finalizing is a simple procedure, necessary to: - be able to play recordings on a CD PLAYER, - avoid further unwanted recordings on a disc, - avoid erasure of tracks on a CDRW, - write CD text on a CDR(W). auto finalizing Auto finalizing is possible when using the MAKE CD recording function. [. . . ] 5 Select the characters by rotating the EASY JOG/ENTER key or by pressing the corresponding numeric/alphabet key on the remote control. 6 Press EASY JOG/ENTER to store each character and move to the next cursor position. ⷠWith the 5 6 keys you can move to a required cursor position. 7 Press STORE/MENU to store a name you have entered and return to the submenu resume at 3 or STOP 9 to exit. [. . . ]