User manual PHILIPS AJ3250

[. . . ] SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24 hour alarm reset option will be automatically selected after 59 minutes, from the time your alarm time first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: · press ALARM RESET during the alarm call. [. . . ] CANCELING THE ALARM COMPLETELY To cancel the set alarm time before it goes off, or during the alarm call: · adjust ALARM 1 or ALARM 2 to OFF position. SLEEP About Sleep This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. Keep your finger on the button and the display will begin to count down from 0:59 to 0:00 minutes. TM To cancel sleep, or to switch off the sleep period press SLEEP OFF /REPEAT ALARM. To adjust the clock and alarm times accurately, always make sure you press the 7 or buttons separately and not simultaneously. 1 Turn the clock control to SET TIME or SET ALARM 1 or SET ALARM 2 to set the clock or alarm time respectively. 2 Press 7 or repeatedly or hold down on the respective button to adjust the hours and minutes. TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. This product complies with the radio interference requirements of the European Union. Move set away from other electrical equipment The alarm does not function ­ Alarm time not set and/or alarm mode not selected · Volume too low for RADIO Adjust the volume Radio alarm not adjusted to radio station Tune to a radio station This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. [. . . ] To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. if the mains plug contains a fuse , this should have a value of 5 Amp. [. . . ]