User manual PHILIPS AJ3011

[. . . ] Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. How to connect a plug The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: · Connect the blue wire to the terminal marked N or coloured black. [. . . ] 3 After you have set both the hours and minutes, press TIME SET to confirm the correct setting. TM Clock time also starts to run automatically after 60 seconds after you adjust the time. Helpful Hint : Press ALARM SET during time setting will switch to alarm setting mode. RADIO 1 2 3 4 5 Press SLEEP / RADIO ON once to switch on the radio. Press ALARM RESET / RADIO OFF to switch off. To improve reception: FM: extend and position the pigtail aerial to obtain optimum reception. SETTING THE ALARM General If you wish to use the alarm, first set the alarm time. The alarm display shows the alarm time all the time and the alarm indicator appears if the alarm is set. Setting the alarm time and mode 1 2 3 Press ALARM SET for more than 2 seconds to enter alarm time setting mode. Press HR or MIN repeatedly or hold down on the button to adjust the hours and minutes respectively. Press ALARM SET to confirm alarm time setting. Helpful Hint : ­ If you press TIME SET when setting the alarm time, the display switches to the time setting mode. ­ It is not possible to adjust the alarm time when the alarm goes off, or when the repeat alarm mode is active. To select the alarm mode you wish to be awoken by, set the ALARM switch to RADIO or BUZZER ( m ) or ( ) appears respectively. · If you have selected the radio mode, make sure you have adjusted the volume loud enough to wake you up!TM The gentle wake buzzer alarm increases its beep tone frequency within seconds. SWITCHING OFF THE ALARM There are three ways of switching off the alarm. [. . . ] Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. [. . . ]