User manual PHILIPS AJ3000

[. . . ] ⷠWhen replacing batteries, the clock time, day and alarm settings will be stored by the self-powered back-up for 3 minutes (See `Self-Powered Back-Up'). ⷠMake sure the radio is switched off to save battery energy. battery lifetime (based on PHILIPS POWER LIFE or alkaline batteries) * Total battery lifetime = 9 months minimum. [. . . ] ⷠIf power supply returns after 3 minutes, the demo mode appears and you will need to re-enter all clock settings. Which affects the display and electronic functions of your set, RESET allows you to clear all previous settings and start up again. ⷠUse a ballpoint pen to press RESET, found on the bottom of the set. Demo mode When the set is first connected to a power supply or has been reset, `PHILIPS' will scroll continuously across the demonstration display until the time and day settings are entered. Display backlight The use of the backlight depends on whether the set is battery or adapter operated. TM The backlight goes out after 2 seconds if the set is battery operated. 2 Press REPEAT ALARM again if you want to: ­ Re-activate the backlight if the set is battery operated. NOTE: During an alarm call, the REPEAT ALARM will only operate for the repeat alarm function. USING THE ALARM General You can set your alarm by radio, buzzer or both. ⷠThe buzzer is at a fixed volume and cannot be adjusted. Setting the alarm by radio or buzzer 1 Press ALARM/TIME/DAY SET once or more until the display shows SET ALARM and the radio m or buzzer k symbol flashes. 2 Press UP 7 or DOWN 8 to set and adjust both the hours and minutes: ­ with your finger held down on UP 7 or DOWN 8 respectively, the time will increase/decrease rapidly and continuously from minutes to hours. ­ If necessary, press UP 7 or DOWN 8 briefly and repeatedly to adjust the time slowly, minute by minute. 4 Press ALARM MODE/OFF once or more to select radio m, buzzer k or both to activate your choice of alarm. [. . . ] ⷠYour set consists of materials which can be recycled if disassembled by a specialized company. Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. [. . . ]