User manual ORION TELESCOPES & BINOCULARS TRAVELTECH TRIPOD

[. . . ] Thread the shoe's shaft into the 1/4"-20 mounting hole on the instrument using the knob on the underside of the shoe. If the instrument has an additional mounting hole for the spring pin, register the pin with the hole before threading in the shaft. Once the shoe is firmly fastened to the instrument, replace the shoe on the head. [. . . ] To adjust the tension on the hand crank when raising and lowering the elevator shaft, rotate the elevator shaft housing. Rotating the housing counter-clockwise loosens the tension, while rotating clockwise increases the tension. You will need to readjust the tension when using the elevator crank to raise or lower instruments of different weights. General Care and Cleaning When using the tripod in direct sunlight, be aware that its black aluminum surfaces can become hot. If the tripod is used in wet conditions, dry it completely with a soft cloth after use. Clean the tripod with mild detergent and a soft cloth. Congratulations on your purchase of a quality Orion product!Your new Traveltech field tripod can support small binoculars, telescopes, still cameras, and video cameras. Designed for use either indoors or outdoors, the Traveltech features a smooth, three-way pan head with a quick-release shoe for convenient operation. To get the most from your new tripod, please take a few minutes to read these instructions and operating tips. Refer to the labeled figure for the names of specific parts of the tripod. To lengthen a leg, release one of the leg lock clamps, then extend a section. Extend one section at a time until all legs are at the desired length. Before mounting an instrument on the tripod it is a good idea to press down on the pan head to make sure the legs are locked securely and will not give way under the instrument's weight. The widest stance is achieved when the tri-brace is as far down as it will go on the elevator shaft housing. Approximate leveling of the tripod should suffice for use with binoculars or spotting scopes. For photographic use, the built-in bubble level aids in achieving more precise leveling. IN 144 Rev. [. . . ] If the product is not registered, proof of purchase (such as a copy of the original invoice) is required. This warranty does not apply if, in Orion's judgment, the instrument has been abused, mishandled, or modified, nor does it apply to normal wear and tear. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. [. . . ]