User manual OREGON WM100

[. . . ] BACkUP POwER 1 piece AAA battery In the case when the rechargeable battery is flat or nearly flat or when the solar panel has been detached, the AAA battery can act as backup power supply for the main unit. 5-6 hours of battery charging will normally provide power to operate unit for 2 months (without using projection feature) or week (using sleep and alarm projection feature daily). When the rechargeable battery is nearly flat or when solar panel has been detached, the (green) LED indicator on the main unit and will flash. [. . . ] Power adapter (not included) The adapter powers the unit and can also be used for charging the rechargeable battery. When connected to the main unit, will be displayed and projection feature can reach its maximum brightness. Make sure the adapter is not obstructed and is easily accessible to the unit. To completely disconnect from power, the adapter should be disconnected from the main unit. For best results when charging the battery, place the solar panel directly with view to sunlight. Do not scratch the solar panel's surface or wipe it with strong detergent. The duration of the rechargeable battery's charging or operating time is determined by either the intensity of sunlight or the position of the solar panel towards the sun. NOTE The main unit and adapter should not be exposed to wet conditions. No objects filled with liquid, such as vases, should be placed on the main unit and adaptor. If you spill liquid over it, dry it immediately with a soft, lint-free cloth. NOTE The technical specifications for this product and the contents of the user manual are subject to change without notice. nOTE Features and accessories will not be available in all countries. If you're in the US and would like to contact our Customer Care department directly, please visit: www2. Hereby, Oregon Scientific, declares that this +ECO Solar Projection Clock (model: RM336PES / RM336PESA / WM100) is in compliance with the essential requirements and other relevant provisions of Directive 999/5/EC. A copy of the signed and dated Declaration of Conformity is available on request via our Oregon Scientific Customer Service. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. DEClARATiON OF CONFORMiTy The following information is not to be used as contact for support or sales. [. . . ]