User manual OREGON TR118

[. . . ] When timer counts to 00H, 00M and 00S, timer buzzer alarm will sound and timer will begin to count up in seconds with a non-flashing timer channel indicator appearing on the display. If both channels are counting down, when time expires in both channels within a minute of each other and the alarm has not been turned off, the alarm for the just expired timer will sound with the other timer channel flashing on the display. The other channel alarm will sound at the completion of cycle, and the indicator will count up. [. . . ] Whenever the clock button is pressed, the time of day will appear in the display. The timer can clip on thin board, belt or shirt pocket using the plastic clip on the backside of timer. The timer can attach to iron or steel surface, using the magnet attached to clip on backside of timer. Use the clip and metal stand bar together to stand clock/timer at an angle on any flat surface. When handled properly, this unit is engineered to give you years of satisfactory service. If the unit comes in contact with water, dry it immediately with a soft lint-free cloth. Do not clean the unit with alcohol containing detergent, abrasive or corrosive materials. Abrasive cleaning agents may scratch the plastic parts and corrode the electronic circuit. Do not subject the unit to excessive: force, shock, dust, temperature, or humidity. Such treatment may result in malfunction, a shorter electronic life span, damaged batteries, or distorted parts. Doing so will terminate the unit's warranty and may cause damage. To activate 24 hour format, in Clock Mode hold START/STOP button down for approximately 3 seconds, beep tone will indicate format change. The numbers can be fast forwarded by holding the individual buttons down for 2 seconds. If an error is made during programming, hold individual HOUR MIN & SEC button down first, then press the clear button until the digit shows zero. Follow the same procedure above for programming the other timer channel. The content of this manual and the product specifications are subject to change without further notice. [. . . ] The website also includes contact information for our customer care department in case you need to reach us, as well as frequently asked questions and customer downloads. We hope you will find all the information you need on our website, however if you'd like to contact the Oregon Scientific Customer Care department directly, please visit: www2. Tryck SEC knappen för återställning av sekundsiffran till noll när sekundsiffrorna är inom 00-29 sekund intervallen; genom att trycka på SEC knappen inom 30-59 sekunders intervallet flyttas minutinställningen framåt 1 minut och återställer sekundsiffrorna till noll. [. . . ]