User manual OREGON THN132ES

[. . . ] Position the sensor close to the main unit during cold winter months as below-freezing temperatures may affect battery performance and signal transmission. If you're in the US and would like to contact our Customer Care department directly, please visit: www2. You may need to experiment with various locations to get the best results. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Initiate a sensor search on the main unit to start receiving temperature (and humidity ­ THGN132ES only) data from the sensor. Wall mount hole RESET: Reset unit to default settings TEST: determines if solar panel is receiving an optimal amount of sunlight Battery compartment CHANNEL switch Remote sensor PROBLEM SYMPTOM Abnormal / strange readings Cannot locate remote sensor Cannot change channel Data does not match main unit REMEDY Press RESET Check battery Check location Check sensors. Only one sensor is working Initiate a manual sensor search The following information is not to be used as contact for support or sales. This product uses 1 AAA rechargeable battery which should be charged via the solar panel. Do not subject the unit to excessive force, shock, dust, temperature or humidity. Do not cover the ventilation holes with any items such as newspapers, curtains etc. If you spill liquid over it, dry it immediately with a soft, lint-free cloth. When disposing of this product, ensure it is collected separately for special treatment and not as household waste. Placement of this product on certain types of wood may result in damage to its finish for which Oregon Scientific will not be responsible. consult the furniture manufacturer's care instructions for information. [. . . ] Ideal placements for the sensor would be in any location on the exterior of the home at a height of not more than 1. 5m (5 ft) and which can shield it from direct sunlight or wet conditions for an accurate reading. NOTE The technical specifications for this product and the contents of the user manual are subject to change without notice. [. . . ]