User manual OPTOMA PK301

[. . . ] Disconnect the battery if the product is not being used for a long period of time. Do not expose the battery to temperatures above +60°C (+140°F) 13. Physical damage/abuse would be (but not limited to): Unit has been dropped. Opening or removing covers may expose you to dangerous voltages or other hazards. [. . . ] Insert the battery with the electrical contacts facing those in the battery compartment. Secure battery into place by pushing it down on the opposite side from the electrical contacts. () Remove the battery by lifting it from the opposite side of the electrical contacts. Slide the battery cover back into place. () 8a 10 4 5 <Note> The standard accessories may vary in each region due to different applications. Standard Accessory 1. USB Female Cable 3 ChargIng the Battery 1 2 PU SH connect vga/componet source - (vIDeo In) 1. The LED Charge Indicator will turn green when battery is fully charged. Before using the first time, charge until battery indicator turns green. After the projector is turned off, the battery may not start charging right away due to the high temperature emitted by the projector. 1. After powering on the projector, press "Auto Search Source Button" to change sources. Connect earphones or amplified external speakers to the audio out connector of the projector ( ) or 4 <Note> 1. All other brand and product names are trademarks or registered trademarks of their respective companies. The connecting cable of video output device is not supplied, please contact their service center. Using with device with audio signal voltage > 0. 3Vrms is not recommended. or or connect vga/componet source - (vga/uSB/hDmI/component In) CONNECT INPUT SOURCE 1. Connect the VGA/Component source device with the Universal I/O connector. After powering on the projector, press "Auto Search Source Button" to change sources. <Note> 1. USB device: Support USB Flash Drive up to 5V/150mA, but does not support USB Hard Disk Drive 2. Female USB cable, Component cable, and HDMI cable are optional accessories. connect vga/componet source Data tranSfer 1. Connect laptop or PC for data transfer to the Projector internal memory or additional MicroSD memory using the supplied Male USB Cable. When connected, switch the Projector on. <Note> The laptop/PC can only detect the input source when the Projector is switched on. The projection will stop when this connection is made. or or or CONNECT HDMI SOURCE 1. After powering on the projector, press "Auto Search Source Button" to change sources. Connect the USB flash drive to the micro USB port using the female USB cable. [. . . ] (See page 3. ) Image Problems No image appears on-screen · Ensure the cables/charger/ battery are correctly and securely connected. Operation Image is out of focus Battery Charging · Adjust the Focus Dial. · Make sure the projection screen Charge Complete is between the required distance 9. 6 to 126. 6 inches (0. 245 to 3. 215 LED Indicator meters) from the projector. Image is too small or too large Message Reminders · Move the projector closer to or · Out of range further from the screen. [. . . ]