User manual OLYMPUS FL-14

[. . . ] AAA (R03) NiMH batteries (× 2) Light-emitting area Auto light receptor Lock ring Lock pin TEST button/CHARGE lamp AUTO CHECK lamp MODE button ON/OFF button Flash control mode lamp (TTL-AUTO, AUTO, MANUAL) x Notes AAA (R03) manganese batteries cannot be used. Continuous firing The flash may become hot when fired many times in succession, resulting in damage or malfunction. [. . . ] 10 EN Shooting (TTL-AUTO) In TTL-AUTO mode, the flash intensity is controlled automatically according to the camera settings (ISO sensitivity and aperture value). Use this mode if the camera is equipped with communication capability. 1 MODE button Press the MODE button of the electronic flash repeatedly to set the flash control mode to [TTL AUTO]. When flash activation has been performed correctly, the AUTO CHECK lamp blinks for about 5 seconds after the shooting. 2 x Notes Some flash control modes are not available depending on camera settings or currently selected shooting modes. EN 11 Shooting (AUTO) In AUTO mode, the auto light receptor adjusts adequate lighting for subject, and light is emitted according to the camera settings (ISO sensitivity and aperture value). 1 2 Press the MODE button of the electronic flash repeatedly to set the flash control mode to [AUTO]. Use "Available shooting range" (Table subject and then shoot. When flash activation has been performed correctly, the AUTO CHECK lamp blinks for about 5 seconds after the shooting. Flash can be tested before shooting; press the TEST button to test flash activation. When the AUTO CHECK lamp blinks for about 5 seconds, the flash is adjusted correctly. For cameras without communication capability Set the ISO sensitivity and aperture value by referring to the shooting range" (Table p. Section of the "Available 12 EN Shooting (MANUAL) 1 2 Press the MODE button of the electronic flash repeatedly to set the flash control mode to [MANUAL]. For the optimum shooting distance to subject, adjust camera settings (ISO sensitivity and aperture value) and then shoot. [. . . ] 00800 - 67 10 83 00 (Toll-free) +49 180 5 - 67 10 83 or +49 40 - 237 73 4899 (Charged) For customers in Europe The "CE" mark indicates that this product complies with the European requirements for safety, health, environment and customer protection. This symbol [crossed-out wheeled bin WEEE Annex IV] indicates separate collection of waste electrical and electronic equipment in the EU countries. [. . . ]