User manual NORTHSTAR EXPLORER 701US OPTIONAL HANDSET

[. . . ] Explorer 701US / 701EU Optional Handset This Installation Sheet is designed to be read with the Explorer 721US and 721EU Operation and Installation Guide. [. . . ] Hold the wallplate at the chosen location and use a soft pencil to mark the 2 screw hole positions and the bulkhead hole position. Drill a 1" (25. 4 mm) bulkhead hole and 2 pilot holes for the screws. Rubber cushion Docking cable Hexagonal nut Bulkhead with hole drilled Locking nut Wallplate Screw Protective end cap Handset curly cable Install the handset bulkhead mount 1. Hold the handset bulkhead mount at the chosen location and use a soft pencil to mark the 2 screw hole positions. Screw the handset bulkhead mount to the chosen location using the screws, nuts and washers provided. Hang the handset on the bulkhead mount. Connect the docking cable to the radio 1. Take the protective end cap off of the handset connector, then push the end of the docking cable into the handset connector. Handset connector Example of a completed installation with a Northstar Explorer 721 Wallplate on bulkhead Handset Handset docking cable M84 Other Northstar product External speaker VHF Antenna External speaker connection cable Antenna connection cable Fuse on RED power cable BLACK power cable Base unit with microphone Battery It is the owner's sole responsibility to install and use the instrument in such a manner that will not cause accidents, personal injury or property damage. and its subsidiaries and affiliates disclaim all liability for any use of this product in a way that may cause accidents, damage or that may violate the law. [. . . ] NorthstarTM is a registered trademark of Brunswick New Technologies Inc. LA000663A-G 0560 [. . . ]