User manual NIKON MB-E5700

[. . . ] Thank you for purchasing the Nikon MB-E5700 battery pack for use with Nikon COOLPIX5700 digital cameras. The MB-E5700 takes six LR6 (AA) batteries (alkaline, lithium, NiCad, or NiMH) and includes alternate shutter-release and zoom buttons to ease taking pictures in vertical-orientation. To ensure proper operation, read this manual thoroughly before using this product. [. . . ] Remove the battery pack contacts cover (Figure 1battery pack is not in use. Be sure to replace the battery pack contacts cover whenever the Remove the coupling contacts cover, also found on the base of the camera, by pushing it down at and sliding it out in the direction of the arrow, as shown in Figure 2A. Fully insert the coupling contacts cover into the coupling contacts cover holder on the MBE5700 as shown in Figure 2A- . Hold the battery-chamber cover at about 45°, gently pull until the peg (Figure 2B- ) pulls free and remove the cover. Insert the battery-chamber cover into the battery-chamber cover holder on the MB-E5700 and slide the battery-chamber cover latch to the position as shown in Figure 2B- . Do not attempt to remove the battery-chamber cover before the coupling contacts cover or you may damage the camera. ⷠTo avoid losing the coupling contacts and battery-chamber covers, be sure to attach each to its respective holder on the MB-E5700. Whenever you attach or remove the battery pack, be sure that the camera is off and that the shutter-release button locking ring on the battery pack is in the L position. ⷠReplace the battery-chamber cover by inserting the cover's right peg into the hole at Figure 2H- , then slide the left peg (closest to the coupling contacts) into its slot. Be sure to replace the battery-chamber cover before the coupling contacts cover. For more information, refer to the Guide to Digital Photography included with your camera. Before inserting batteries, be sure that the camera is off and that the shutter-release button locking ring on the battery pack is in the L position. Insert six LR6 (AA) batteries, taking care to orient the battery terminals as shown on the inside of the battery holder (Figure 2F). Slide the battery holder into the battery pack and slide the battery holder latch to the position (Figure 2G). Turn the camera on and check the battery level in the control panel, or in the monitor or viewfinder. If you will not be using the battery pack for long periods, remove the batteries to prevent leakage. [. . . ] 3 oz), excluding batteries Specifications and design are subject to change without notice. Controleer voordat u het battery pack aansluit of de camera uit staat en of de vergrendeling van de ontspanknop (figuur 1van het battery pack in de stand L staat. Controleer voordat u het battery pack aansluit of ontkoppelt of de camera uit staat en of de vergrendeling van de ontspanknop van het battery pack in de stand L staat. [. . . ]