User manual NIKON EH-65A AC ADAPTER

[. . . ] Federal Communications Commission (FCC) Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. CAUTION Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Nikon Corporation may void the user's authority to operate the equipment. For USA only: Over AC 125V Use a power cord suited to the voltage in use with AC 250V AC 15A rated plugs (NEMA 6P-15) and a minimum of SVT type cord for insulation and for anything over AWG 18 in size. Make sure the EP-60 is oriented correctly and insert it into the battery chamber (Figure 2-b). ⷠOpen the power connector cover ( ) and close the battery-chamber/memory card slot cover, making sure the EP-60 DC IN connector cord goes through the power connector opening ( ). Slide the cover latch until the red dot is hidden ( ), indicating that the cover is latched (Figure 2-c). To ensure a proper connection, make sure the DC plug is fully inserted into the DC IN connector. When operating the camera with the AC adapter kit, take care that the camera does not accidentally become unplugged. [. . . ] To ensure a proper connection, make sure the DC plug is fully inserted into the DC IN connector. When operating the camera with the AC adapter kit, take care that the camera does not accidentally become unplugged. [. . . ]