User manual NIKE TAILWIND

[. . . ] This document with updates is available online at www. nike. com /manuals 6 6 6 6 6 7 7 1 Quick Start Follow steps through to position the SDM tailwind and go for a run. SECURING STRAP BASE CLIP Unfasten the securing strap and lift hinged speed sensor from base. Slide base under laces, then press speed sensor until it clicks into place. Power ON/OFF 1. 5 SEC Fasten securing strap over speed sensor. 2 Clear or Reset in any Mode 7 6 Start/Stop in any Mode 5 Accumulated Distance Distance Total Time Average Pace Calories Burned 3 Set-Up Follow steps through to personalize your SDM tailwind. 1 1. 5 SEC 2 distance units gender weight units weight age 4 Calibration Go to a 400 meter marked track and follow steps through to calibrate SDM tailwind. 400 meter 1 5 SEC 5 SEC 1 Go to a 400 meter marked track. [. . . ] Finally, it should be aligned with the foot and secured well enough that the alignment does not change during a run. Orthotics: People who wear orthotics or have extreme pronation or supination in their stride may experience reduced accuracy. Varying Paces: People who run at varying paces within a run may experience reduced accuracy. Try calibrating at the speed you usually run. Mode Limits Chronograph: 23:59'59" Material Specifications Crystal: Polycarbonate Strap: Polyurethane Case: Plastic Resin Clip: Plastic Resin Battery Battery Type: 1 AAA Battery Life: About 70 hours Battery Replacement: Follow the steps below to replace your SDM tailwind battery. [. . . ] See page 7 for service center information. AAA battery Open the battery lid on the pod with a coin by turning counterclockwise. Insert a AAA battery with the + mode facing you. Replace the battery lid. 6 [. . . ]