User manual NEWPOL XS 271EV

[. . . ] Improper use of the appliance can lead to personal injury and material damage. READ AND SAVE THESE INSTRUCTIONS This appliance is designed to vent cooking smoke and odors only. Be certain your appliance is properly installed and grounded by a qualified technician. To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. [. . . ] Automatic Safety Shut Off The fan will turn off automatically 10 hours after the last button was activated. The light button indicator will go out. Dimming the lighting The brightness of the lighting can be adjusted. ^ If the button is pressed again, the lighting will brighten until the button is released. If the button is pressed continuously, the light will cycle between bright and dark. ^ Press the light button again to turn off the lighting. 11 Operation Grease filter timer A timer monitors the hours of fan operation. The indicator for the grease filter will light after 30 hours of operation. After the grease filters have been cleaned and put in place, the grease filter timer must be reset. Checking the grease filter timer To check the percentage of time already used: ^ Press the On/Off button to turn the fan on. ^ To do this, press the grease filter button for about 3 seconds. The indicator will go out. ^ Press the grease filter button. The number of flashing _ indicators show the percentage of programmed hours that have been used. 1 indicator = less than 25 % 2 indicators = less than 50 % 3 indicators = less than 75 % 4 indicators = less than 100 % This information will remain stored in memory in the event of a power failure. 12 Operation Reprogramming the grease filter timer The grease filter timer is preset to 30 hours. ­ A time of 20 hours should be programmed in kitchens with frequent pan or deep frying. Its mounting bracket must be firmly attached to the stud framing behind the drywall. If studs are not located in the required locations, a plywood backing (min. 1/2 " (13mm) thick) spanning at least two studs must be installed. Failure to adequately support the weight as stated may result in the Ventilation System falling off the wall causing injury and property damage. ^ Find the studs to the left and right of the mounting location by tapping the wall or using a stud finder. Be careful not to damage any wiring or plumbing that may be located behind the wall. Make sure that the power supply to the area being worked in has been turned off at the breaker panel before cutting into the wall. ^ Cut out the drywall along the marked lines and replace it with plywood of a matching thickness (min. ^ To complete the installation proceed to "Attaching the hood and motor assembly to the wall. " (If plywood backing is not needed, proceed to "Attaching the hood and motor assembly to the wall. ") To install a plywood backing board ^ Determine and mark the location of the motor assembly as outlined in "Attaching the hood and motor assembly to the wall. " ^ Mark a horizontal line 3" (76 mm) above and 9" (229 mm) below the mounting screw locations. 24 Electrical data All electrical work should be performed by a qualified electrician in strict accordance with national and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous. Ensure that power to the appliance is OFF while installation or repair work is performed. [. . . ] Insert the 6 prong connector into the receptacle right of the motor assembly. ^ Plug in the power cord. ^ Carefully ease apart the sides of the chimney extension and hook it behind the upper retaining plate. Be careful of sharp edges. ^ Push the chimney extension flush against the ceiling and use 2 of the small screws to attach it to the top of the retaining plate. 32 Installation The shields will protect the finish of the extension during the rest of the installation. ^ Peel off the backing from the tape on the protective shields. ^ Stick the shields on the sides of the chimney extension (see illustration). ^ Carefully ease apart the sides of the chimney and slide it over the extension. [. . . ]