User manual NEWPOL XS 251CO

[. . . ] appliance, switch power off at the service panel and lock the service disconnecting means to prevent power from being switched on accidentally. If the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. If there is any doubt, have the electrical system of the house checked by a qualified electrician. ~ b) Before servicing or cleaning the ~ This appliance is intended for ~ This appliance complies with current safety requirements. [. . . ] ­ A time of 20 hours should be programmed in kitchens with frequent pan or deep frying. ­ A time of 20 hours should also be programmed if the kitchen is only used occasionally. Otherwise grease which has accumulated over a long period of time will harden on the filters making cleaning more difficult. Reprogramming the grease filter timer The indicator for the grease filter and one of the "­/+" indicators will flash. The lit indicator shows the programmed time: 1st indicator from the left 2nd indicator from the left 3rd indicator from the left 4th indicator from the left = = = = 20 hours 30 hours 40 hours 50 hours ^ Use the "­/+" buttons to select the desired time. ^ Press the On/Off button to turn off the fan. ^ Store the selection by pressing the grease filter button. ^ Press the Delayed Shut Down and grease filter buttons at the same time. If the procedure is not stored within 4 minutes of programming, the hood will automatically default to the "old" data. 15 Operation Reprogramming the charcoal filter timer The active charcoal filter can only be used in recirculation mode and can not be used to exhaust fumes. Before using the hood in recirculation mode, the charcoal filter timer must be programmed. The indicator for the charcoal filter and one of the "­/+" indicators will flash. The lit indicator shows the programmed time: 1st indicator from the left = 120 hours 2nd indicator from the left = 180 hours 3rd indicator from the left = 240 hours 4th indicator from the left = deactivated ^ Use the "­/+" button to select the desired time. ^ Turn off the fan using the On/Off button. ^ Press the Delayed Shut Down and Charcoal Filter buttons at the same time. ^ Store the selection by pressing the charcoal filter button. If the procedure is not stored within 4 minutes of programming, the hood will automatically default to the "old" data. 16 Cleaning and Care , WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Before cleaning or servicing the hood, disconnect it from the power supply, see "Important Safety Instructions". Avoid: ­ cleaning agents containing soda, acids, solvents or chlorides, ­ abrasive cleaning agents e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents. ­ limescale removers Cleaning the casing Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. ^ All external surfaces and controls can be cleaned with a mild solution of warm water and liquid dish soap applied with a soft sponge. See "Cleaning and Care". ^ To remove the active charcoal filter pull down on the tab at the back of the filter. ^ Before inserting an active charcoal filter for the first time remove the connector for use in air extraction mode. Loosen the screw in the connector and remove. ^ Insert the new charcoal filter on an angle toward the front of the hood and then firmly press the rear in place. ^ When the active charcoal filter is installed for the first time, program the charcoal filter timer. See "Operation - Reprogramming the charcoal filter timer". 20 Cleaning and Care Replace the active charcoal filter when the charcoal filter indicator lights. Replace the filter at least every 6 months or when it no longer absorbs odors efficiently. ^ After replacing the charcoal filters, press and hold the charcoal filter button for about 3 seconds to reset the charcoal filter timer. ^ If the charcoal filters are replaced before the timer has reached its maximum, the charcoal filter button should be pressed for 6 seconds to reset the counter to zero. 21 Cleaning and Care Changing the light bulbs , WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Before changing the light bulbs, disconnect the hood from the power supply, see "Important Safety Instructions". ^ Remove the decor cover, see "Cleaning and Care / Removing the decor cover". ^ Pull the old bulb out of its socket and replace it with a new one of the same type. Be careful not to drop the bulb on the cooktop. When in use halogen bulbs become extremely hot, and they can burn your hands. Do not attempt to change the bulbs until they have had sufficient time to cool down. [. . . ] Gas cooking appliances release carbon monoxide that can be harmful or fatal if inhaled. To reduce the risk of fire and to properly exhaust air, the exhaust gases extracted by the hood should be vented outside of the building only. Do not vent exhaust air into spaces within walls or ceilings or in attics, crawl spaces or garages. Please read and follow the "IMPORTANT SAFETY INSTRUCTIONS" to reduce the risk of personal injury. [. . . ]