User manual MTD OEM-290-254
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual MTD OEM-290-254. We hope that this MTD OEM-290-254 user guide will be useful to you.
Manual abstract: user guide MTD OEM-290-254
Detailed instructions for use are in the User's Guide.
[. . . ] Tiller Bumper/Guard
OEM-290-254 / 290-254-081
Introduction
Thank you for purchasing this Bumper/ Guard for your tiller. [. . . ] IMPORTANT: When removing the engine mounting screws in Step 3, do not allow the engine to move out of position on the left and right side engine support brackets. It is critical to proper belt alignment that the same mounting holes in the engine support brackets be used when installing the bumper mounting screws. Loosen (do not remove) the hex nuts on the four screws that secure the engine to the left and right side engine support brackets. Without moving the engine, remove the four screws, lockwashers and hex nuts. On the left side of the engine, loosely attach the bumper with the two new screws, lockwashers and hex nuts provided in the kit (lockwashers go next to hex nuts). The screws can be installed in either direction, but facing downward is preferred, if room allows.
CAUTION
TO PREVENT INJURY FROM MOVING PARTS OR HOT SURFACES: • Stop the engine and wait for all moving parts to stop. [. . . ] BOX 361131, CLEVELAND, OHIO 44136-0019, 1-866-840-6483
Printed in U. S. A. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE MTD OEM-290-254
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual MTD OEM-290-254 will begin.