User manual MINOURA MAGTURBO ERGO

[. . . ] If you want to ride MTB on this trainer, we strongly recommend to replace the rear tire from knobby one to a slick one in order to avoid vibration and noise problem caused by the tire pattern. Enjoy your workout with Minoura Magturbo trainer. -1- IMPORTANT NOTES · Read all instructions carefully before use. Lost instruction materials can be replaced through Minoura or your local dealer. [. . . ] Otherwise the inside Nylon nut located in the metal cap of the Hub Handle may come loose. Loosen the Knob Bolt enough until the wheel can be placed without touching the Drive Roller on Mag resistance unit. C) While holding your bicycle, tighten the Hub Handle in a clockwise direction until you see the couplings come in contact, and engage the heads of your QR lever. 1 2 3 (Fig. C) 4 Stop tightening the handle after the couplings have engaged the QR. You should NOT be able to move the bicycle without also moving the trainer. If the bicycle moves within the couplings AT ALL, continue to tighten the handle until you see no movement of the bicycle within the couplings. Please be sure not to tighten the couplings past the point that the bicycle does move within the couplings. Over tightening can cause both your bicycle and trainer to sustain damage. -4- 5 Tighten the knob bolt until it starts to move the drive roller towards your tire. Once the drive roller comes in contact with your tire, tighten the knob bolt another half or one more turn. This is a guidleine and adjustment one way or the other may be necessary in order to provide the best contact. D) Be sure too much or too few roller pressure to the tire will cause a problem such as wearing down so quickly. (Fig. D) -5- USING THE MAGTURBO UNIT The Magturbo unit has seven different levels of load force, replicating actual riding resistance. The load settings range from high (H) to low (L) and can be adjusted via the white lever on the Magturbo unit or the lever on the thumb shifter device. The rider may also adjust the load force by shifting up or down among his gears, depending on the level desired. We recommend that you start with a medium to low load force and gradually work up, increasing force as muscled warm up. Increasing Load Force To increase the load force, move the white lever on the Mag unit toward the (H) symbol. [. . . ] H) If you cannot shift to either the lowest (L) or the highest (H) position, it is possible that the inner wire of the remote shifter cable is too long and the wire tension is loose. Remove the remote shifter device from the handlebar and straighten the cable. Hold the adjusting screw with your right hand and push it towards the direction of the outer cable, then adjust the nut with your left hand to make the wire tension properly. [. . . ]