User manual MINOURA HYPERMAG1200-LW

[. . . ] Remove all oils and moisture from the drive roller and the tire before use. Keep both hands on handlebars at all times and maintain a normal riding position. Check the couplings supporting the rear hub for damage and cracks (see Fig. [. . . ] If the tire touches either left or right side platic housing of the Mag unit (see Fig. D), you must adjust the Mag unit position by loosening two bolts beneath the Mag unit. D) Turn the micro adjust knob clockwise to bring the drive roller into contact with the rear tire. If the tire is compressed about 3mm by the roller, stop turning the knob. WARNING: Too much or too little contact between the tire and the roller can cause premature tire wear and possibly damage the drive roller. C) 6 ! Using The Mag Unit The Magturbo unit has 7 different levels of load force, replicating actual riding resistance. The load settings range from high (H) to low (L) and can be adjusted via the white lever on the Magturbo unit or the lever on the thumb shifter device. The rider may also adjust the load force by shifting up or down among his gears, depending on the level desired. We recommend that you start with a medium to low load force and gradually work up, increasing force as muscled warm up. -3- Increasing Load Force To increase the load force, turn the lever on your thumb shifter device toward the "H" symbol. E) To decrease the load force, turn the lever on your thumb shifter device toward the "L" symbol. Be sure the lowest selection is not zero load, there still be a small level of force. HOW TO INSTALL THE REMOTE LEVER You can install the remote lever on anywhere the diameter is between 22. 2mm (7/8") and 31. 8mm (1-1/4") like as on the handlebar. 1 2 Fully loosen the knob bolt on the plastic holder until it stops then push down the bolt to open the holder. F) Place the holder onto the handlebar, shut the holder, and pull up the bolt then tighten it. H) ! Depends on the diameter of your handlebar, you must adjust the shim as follows; · 22. 2mm (7/8") - 25. 4mm (1"):Install both shims. [. . . ] I) Trouble Shooting Your Remote Shifter Unit If you cannot shift to either the lowest (L) or the highest (H) position, it is possible that the inner wire of the remote shifter cable is too long and the wire tension is loose. If so, please adjust the tension with the following steps; Nut Plastic Cap Cable 1 2 3 Set the remote shifter lever at "H" position. Remove the remote shifter device from the handlebar and straighten the cable. [. . . ]