User manual MB QUART ZURICH INSTALLATION

[. . . ] Although the speakers sound best when the back section of the speaker is left in tact. The back section of the speaker can be removed to lessen the over all mounting height if needed. Some building codes may require that the back enclosure half be removed so please check with your local building codes. [. . . ] Avoid electrical wiring, plumbing, moving parts, air ducts and Fire Stops. Use a drywall saw or other appropriate tool to carefully cut out the speaker holes. You also can go as much as 1/4" over this size as "Mistake Room". Connect the speaker wires (16 gauge wire not supplied) to the speakers as shown in DIAGRAM 5. Place the speaker into the speaker opening and using a # 2 phillips screw driver, turn the Dog-Ear fastening screws clockwise (be sure to support the weight of the speaker until all Doq-Ear screws are securely tightened). The Doq-Ear Clamp will rotate away from the speaker enclosure and begin to tighten against the mounting surface to secure the speaker as shown in DIAGRAM 6. Carefully route the speaker wires to the amplifier or other power source. Be sure to avoid moving parts, heat producing items and water exposure. DIAGRAM 4 RIGHT REAR RIGHT FRONT TV 5. 1 or 7. 1 System CENTER LEFT FRONT LEFT REAR 4 DIAGRAM 6 DIAGRAM 5 (1B) Dog Ear Clamps Drywall Note: As you turn the Dog-Ear screws clockwise, the Dog-Ear Clamps will swing out away from the speaker (1A). Continue to turn the screw and the Dog-Ear Clamps will Lower down until they reach the mounting surface (1B) Dog Ear Screw (1A) To amplifier or surround sound receiver 8-Ohms Dog Ear Clamps Removable Enclosure Back Case The back section of the enclosure can be removed when mounting depth does not permit the full height of the speaker enclosure 5 ADDITIONAL INSTALLATION AND OPERATIONAL INFORMATION - If you do not have the installation cut-out template, the cut-out dimensions are also located on the speaker label located on the side of the speaker. You can also down load the template by going to our web site at: www. maxxsonics. com - The speaker trim bezels and grilles can also be spray painted. There is a paint shield located in the speaker kit to prevent from getting paint on the speaker cone. Tip: Do not use roll-on paint because it will fill-in the holes in the grille which will dramatically effect the sound quality. Be sure to paint the grille separate from the speaker and do not re-install the grille until the paint has dried. - You may order additional parts such as Dog-Ear Clamps, Grilles, Grille removal tools by contacting Maxxsonics at www. maxxsonics. com - To enhance your total Surround Sound experience, be sure to consider the ZUR10SW or ZUR12SW powered subwoofer system which will provide heart pounding bass to your favorite action movies. For the ultimate in Hi Fi sound quality, check out the MB QUART 5. 1 speaker systems (Tower speakers, center channel and book shelf speakers) In-Ceiling Speaker Mid Range Speaker In-Wall Speaker Mid Range Speaker Tweeter Element Or Or Or Or Tweeter Element Tweeter Angle Adjustment The tweeter element can be swivelled to allow you to aim or point the tweeter towards the listening area as shown above. In the event the mid bass speaker can not be aimed towards Tweeter Angle Adjustment The tweeter element can be swivelled to allow you to aim or point the tweeter towards the listening area as shown above. [. . . ] This warranty does not cover abuse, damage, cosmetic damage or damage due to misuse, accidents, negligence, Acts of God, Commercial Use, or modification of, or to any part of the product. This warranty does not cover damage due to improper operation, maintenance or installation, or attempted repair by anyone other than MB QUART or a MB QUART dealer which is authorized to do MB QUART warranty work. THE EXCLUSIVE REMEDY OF THE CONSUMER PROVIDED UNDER THIS WARRANTY IS REPAIRS OR REPLACEMENTS OF PRODUCT. [. . . ]